HIKOKI DH 24PX2 Manual Petunjuk Penanganan - Halaman 7
Jelajahi secara online atau unduh pdf Manual Petunjuk Penanganan untuk Palu Putar HIKOKI DH 24PX2. HIKOKI DH 24PX2 16 halaman.
Halaman Cetak
Front cap
Drill chuck
Chuck adapter
CAUTION
○ Application of force more than necessary will not only
expedite the work, but will deteriorate the tip edge of the
drill bit and reduce the service life of the rotary hammer
in addition.
○ Drill bits may snap off while withdrawing the rotary
hammer from the drilled hole. For withdrawing, it is
important to use a pushing motion.
○ Do not attempt to drill anchor holes or holes in concrete
with the machine set in the rotation only function.
○ Do not attempt to use the rotary hammer in the rotation
and hammering function with the drill chuck and chuck
adapter attached. This would seriously shorten the
service life of every component of the machine.
4. When driving machine screws (Fig. 10)
(1) Insert the bit into the socket in the end of chuck adapter (D).
(2) Mount chuck adapter (D) on the main unit using
procedures described 4(1), (2), (3) on page 5 put the tip
of the bit in the slots in the head of the screw, grasp the
main unit and tighten the screw.
Bit
Socket
Chuck adapter (D)
CAUTION
○ Screw heads or bits will be damaged unless a bit
appropriate for the screw diameter is employed to drive
in the screws.
○ Exercise care not to excessively prolong driving time,
otherwise, the screws may be damaged by excessive
force.
○ Apply the rotary hammer perpendicularly to the screw
head when driving the screw; otherwise, the screw
head or bit will be damaged, or driving force will not be
fully transferred to the screw.
○ Do not attempt to use the rotary hammer in the rotation
and striking function with the chuck adapter and bit
attached.
5. When driving wood screws (Fig. 10)
(1) Selecting a suitable driver bit
Employ plus-head screws, if possible, since the driver
bit easily slips off the heads of minus-head screws.
Grip
Part of SDS-plus shank
Fig. 9
Front cap
Grip
Fig. 10
Screw heads or bits will be damaged unless a bit
appropriate for the screw diameter is employed to drive
in the screws.
(2) Driving in wood screws
○ Prior to driving in wood screws, make pilot holes
suitable for them in the wooden board. Apply the bit to
the screw head grooves and gently drive the screws
into the holes.
○ After rotating the rotary hammer at low speed for a
while until the wood screw is partly driven into the
wood, squeeze the trigger more strongly to obtain the
optimum driving force.
CAUTION
Exercise care in preparing a pilot hole suitable for
the wood screw taking the hardness of the wood into
consideration. Should the hole be excessively small or
shallow, requiring much power to drive the screw into
it, the thread of the wood screw may sometimes be
damaged.
6. Hammering only
This rotary hammer can be set to hammering only mode
by pressing the push button and turning the change
mark (Fig. 11).
lever to the
Change lever
(1) Mount the tool. (Bull point, cold chisel etc.)
(2) Press the push button and set the change lever to ●
mark between
mark and
The rotation is released, turn and adjust the tool to
desired position (Fig. 13).
Change lever
Tool
Push button
Fig. 11
mark (Fig. 12).
●
Push button
Fig. 12
Fig. 13
7