AGT INDUSTRIAL AGT-WB24 Panduan Produk - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Produk untuk Penyeimbang Roda AGT INDUSTRIAL AGT-WB24. AGT INDUSTRIAL AGT-WB24 18 halaman.

TWO. Installation

1.machine installation

The equipment must be installed on a solid cement floor or similar. If the ground is not solid,

measurement error will be caused. There should be space around the equipment for easy operation. See

below:

Note: This diagram does not represent the form factor of the equipment you actually purchased,

and this figure is for installation location reference only.

The position of the mounting hole of the machine base should be fixed by expansion screw.

3. main shaft screw installation

Install the equipped screw on the main shaft, and tighten it (see below picture)

Note: when installing and removing the wheels, do not allow the wheels to slide on the main shaft screw to

avoid scratches.

THREE .Display Panel