GAME SolarPRO XB Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Pemanas Kolam Renang GAME SolarPRO XB. GAME SolarPRO XB 12 halaman.

GAME SolarPRO XB Panduan Pemilik
1.

SAFETY WARNINGS

• Carefully read and adhere to all CAUTION and NOTE notices located throughout this manual
Failure to comply with these instructions can cause serious injury, death, or damage to the unit
• Do NOT allow children to operate this product
• Always turn the filter system to a setting that does not allow flow to the pool return when installing
or working on the solar heater
• Install product away from the pool to prevent children from using the heater as a way to access the pool
• NEVER service this unit with the pool pump running
• Do not use any petroleum based lubricant Petroleum based products will destroy plastic parts
THESE CAUTION WARNINGS ARE NOT INTENDED TO INCORPORATE ALL POSSIBLE INSTANCES
FOR RISK AND/OR SEVERE INJURY. THE POOL OWNER SHOULD ALWAYS EXERCISE CAUTION
AND COMMON SENSE WHEN UTILIZING THEIR SWIMMING POOL AND OPERATING EQUIPMENT.
IMPORTANT: A BYPASS KIT (GAME ITEM 4555, SOLD SEPERATELY) IS REQUIRED FOR
CONNECTING MULTIPLE HEATERS. CALL GAME CUSTOMER SERVICE, 1.888.339.2546
2.

GENERAL INFORMATION

This manual provides information relating to the installation, utilization and maintenance of our solar heater We recommend you
read this manual in its entirety and keep it for future reference
The solar heater you just purchased for your above ground pool is simple to install and effortless to operate once connected The
installation instructions included in this manual are based on a few assumptions: 1) you have an existing above ground pool that is
completely set up and filled with water, 2) your above ground pool is equipped with a pump-operated water filtering system, and 3)
you have the necessary hoses needed to feed water in and out of your pool and filter system
These assumptions are necessary as the solar heater, once installed, will be completely dependent upon your pool's filter pump to
push water in and through the heater's solar coils
NOTE: Approved for use with any cartridge or sand filter up to ½ HP or filter systems with flow rates less

How It Works

When properly installed, the solar heater will be connected to your filter and your pool by two hose connections: One hose will feed
cold, filtered pool water from your pump into one port of the solar heater The other hose will feed sun warmed water from the other
port of the solar heater to your pool via the pool return inlet in your pool As cold water is fed into the solar heater, it travels through
the solar coils where it is heated by the sun before it is delivered back into your swimming pool

Unpacking Your Solar Heater

Carefully remove the product and all component parts from the box Make certain all parts are present before beginning assembly
(see Section 2, Parts List/Reference)
Refer to Appendix for a complete EXPLODED VIEW PARTS DIAGRAM.
Tools & Equipment Required
The following items are not included with your new solar heater, but will be required for proper installation and operation:
• ¼" Flat head screwdriver
• Silicone based lubricant
SAVE THESE INSTRUCTIONS
READ ALL WARNINGS BELOW. FAILURE TO DO SO COULD RESULT
IN SERIOUS PERSONAL INJURY OR DEATH.
than 2500 gallons/hour. Use of any other type of pump will void the warranty.
4