HIKOKI C 7SB3 Manual Petunjuk Penanganan - Halaman 11

Jelajahi secara online atau unduh pdf Manual Petunjuk Penanganan untuk Melihat HIKOKI C 7SB3. HIKOKI C 7SB3 16 halaman.

Halaman Cetak

5. Replacing supply cord

If the replacement of the supply cord is necessary, this

has to be done by the manufacturer of this agent in order

to avoid a safety hazard.

6. Motor unit maintenance

The motor winding is an important part of this tool. Avoid

damaging and be careful to avoid contact with cleaning

oil or water.

After 50 hours of use, clean the motor by blowing into the

ventilation holes of the motor housing with dry air from an

air gun or other tool (Fig. 16).

Dust or particle accumulation in the motor can result in

damage.

7. Inspecting and maintaining the lower guard

Always make sure that the lower guard moves smoothly.

In the event of any malfunction, immediately repair the

lower guard.

For cleaning and maintenance, use an air gun or other

tool to blow clean the space between the lower guard

and gear cover as well as the rotation part of the lower

guard with dry air (Fig. 16).

Doing so is eﬀ ective for the emission of chips or other

particles.

Accumulation of chips or other particles around the lower

guard may result in malfunction or damage.

WARNING

To prevent dust inhalation or eye irritation, wear

protective safety goggles and a dust mask when

using an air gun or other tool to clean the lower guard,

ventilation holes or other parts of the product.

Ensure smooth movement

of lower guard

Space between lower

guard and gear cover

Housing vent

CAUTION

In the operation and maintenance of power tools, the safety

regulations and standards prescribed in each country must

be observed.

NOTE

Due to HiKOKI's continuing program of research and

development, the speciﬁ cations herein are subject to

change without prior notice.

Rotation part of the

lower guard

Air gun

Fig. 16