Maintronic XRD600 REG Manual - Halaman 13

Jelajahi secara online atau unduh pdf Manual untuk Peralatan Pencahayaan Maintronic XRD600 REG. Maintronic XRD600 REG 18 halaman. Dmx-retrofit-dimmer

For example, perform a factory reset:

Press one of the two buttons (device button

or push button

, after 20 seconds the LED il-

luminates for 2 seconds, which shows phase 1.

Hold the button pressed in, phase 6 is followed by

a slightly longer pause until phase 7 is activated.

During these 2 seconds of the activated phase the

push button must be released.

The dimmer is now reset to the factory settings.

8. Operation via DMX

To operate a device with DMX, a DMX512 control-

ler is required. A gateway can also be used to crea-

te an interface to other protocols such as KNX...

A supply voltage of 24V DC must be available (cur-

rent consumption per module <7mA). Within the

DMX protocol, a correct clamping of the signal line

with + 24V and -GND must be ensured.

NOTE - Before operating the dimmer, it is

necessary to send a DMX signal once. As

long as the DMX input is used (DMX signal

is transmitted), the device button and

push button inputs are not active. One se-

cond after the last DMX signal has been

received, the button inputs are reactivated

again.

www.maintronic.de

According to the DMX standard, no more than 32

DMX devices (with separate power supply) should

be connected to a DMX signal. Then the DMX sig-

nal must be amplified with a repeater. To supply

the bus, a supply voltage of 12 - 24V DC must be

present (current consumption per module <7mA).

If your controller has a masterfader or overall vo-

lume control, make sure that the DMX value 255

(Max. Level) is adjustable, otherwise no program-

ming can be performed.

A value from 1 to 512 can be assigned as start

address. In the delivery state, the start address (of

the device) is preset to 1. The module uses one

DMX channel.