Adexa EC1N Buku Petunjuk - Halaman 5
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Peralatan Dapur Adexa EC1N. Adexa EC1N 8 halaman. Electric crepe maker
Halaman Cetak
Instruction Manual
Trouble Shooting
Problem
Indicator light will not turn on and
unit will not heat
Heating indicator is not on.The
temperature is not increasing
Power indicator is on but the
desired temperature is not
reached
Temperature control is normal but
indicator is not on
Temperature indicator is on.But
heater tube is not hot
Temperature can not be controlled ⚫
Do not use the machine if any of the above occur.
Any troubleshooting corrections should be performed by a qualified technician
Daily Check
Before using the machine, visually inspect for any signs of damage or frayed power cord. Be certain
machine is on a level countertop.
After turning it on, check for anything unusual before you use it.
Inspect the machine every day before using. If there is any question about operation, do not use
Caused
⚫
Plug not properly in-serted
⚫
On&Off power switch broken
⚫
Electric heater tubes is not
properly connected.
⚫
Heater is defective
⚫
Temperature controller is burned
out
⚫
Indicator light is burned out
⚫
Temperature limiter has tripped
Temperature Limiter is out of
order
Solution
Plug unit in
Replace power switch
Tighten both sides of electric heater
Replace electric heating tube.
Replace Thermostat Control
Replace indicator.
Reset over heating protecting button by
hand on bottom of electrical box
Replace temperature limiter/Rest Button
4