Airfield Audio Liminator 2 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Peralatan Perekaman Airfield Audio Liminator 2. Airfield Audio Liminator 2 9 halaman. Class a dual transformer stereo compressor

Halaman Cetak

1. IMPORTANT : SET THE MAINS SWITCH ON THE REAR PANEL TO THE

CORRECT VOLTAGE.

2. Be certain that the unit has a ½ AMP fuse (115 VAC mains)

or ¼ AMP fuse (230 VAC mains).

3. Connect line level audio input cables from your source (microphone preamp, EQ,

analog console or DAW outputs) to the 3 pin XLR female connectors. The input

XLR connectors are Balanced Transformer Coupled, pin 2 hot.

4. Connect audio output cables to the 3 pin XLR male connectors and plug them into

your recording/mixing device. The output XLR's are Balanced Transformer

Coupled, pin 2 hot.

5. Connect the supplied IEC power cable to the IEC mains socket on the rear panel.

USE ONLY A 3 PRONG GROUNDED POWER CABLE. For safety reasons do

not lift the ground on the power plug by using a 3 to 2 ground lift adapter.

6. Link Jack: connect a standard ¼" unbalanced guitar type cable or Y-cables.

Should be used for multi-channel operation of three or more Liminator channels.

7. Turn on the unit and allow 30 minutes warm up.

INSTALLATION

REAR PANEL VIEW

- 3 -