Bristan ALP 2HBF C Petunjuk Pemasangan & Panduan Pengguna - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Panduan Pengguna untuk Produk Pipa Bristan ALP 2HBF C. Bristan ALP 2HBF C 20 halaman.

Installation Cont.

Wall Mounted Basin Mixer and Bath Filler

1. Remove the spout from the basin mixer / bath

filler by loosing the grub screw.

2. Decide on the final position of the basin mixer/

bath filler. Install suitable battons into the wall

cavity if required.

3. Secure the mixer body using the screws and wall

plugs supplied.

4. Plumb the hot and cold water supply pipes to

the required position and flush through to remove

any debris. Attach pipework to the hot and cold

inlets (hot on the bottom and cold on the right when

viewed from the front) ensuring the olive is fitted to

the copper pipe work. Tighten the compression nut

to secure pipework and create a water tight seal.

Note: Before finishing the wall surface turn on the

water supplies to check for any leaking connections.

5. Finish the wall surface.

Note, it is important sufficient thread is left exposed

to allow the spout to connect.

6. Attach the spout to the concealing plate using the

screws supplied.

7. Push the concealing plate / spout over the valve

shroud ensuring the O-rings on the spout

connecting tube have located inside the spout.

Tighten the grub screw on the under side of the

spout to secure in position.

8. Place the cartridge shroud over the cartridge and

push the shroud cover onto the cartridge shroud.

Tighten the grub screw.

10. Push the handle onto the cartridge and tighten

the grub screw.

11. Operate the basin mixer / bath filler to ensure it

is functioning correctly.

Cold

Hot

Cartridge

Shroud

Cover