Bristan Descent DSC BAS C Panduan Petunjuk Instalasi - Halaman 11
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Produk Pipa Bristan Descent DSC BAS C. Bristan Descent DSC BAS C 16 halaman. Tap
Juga untuk Bristan Descent DSC BAS C: Petunjuk Instalasi dan Panduan Pengguna (16 halaman)
Halaman Cetak
Installation Cont.
Floor Standing Bath Shower Mixer
1. Mark the fixing holes of the base onto the
floor surface at the required position, also
marking a central hole for the flexi tails to go
through.
Note: If the bath shower mixer is to be fitted
onto wooden floorboards, the boards must be
reinforced with additional wooden batons due
to the height and weight of the bath shower
mixer. If the floorboards are not reinforced this
may result in the mixer flexing slightly during
operation.
2. Drill suitable holes for the fixings and the
central hole.
3. Terminate suitable pipework for the water
supplies under the floor and ensure the flexi
tails will be able to connect once the bath
shower mixer is fitted.
4. Slide the plinth along the mixer body and
thread the flexi tails through the fixing base.
Thread the flexi tails through the central hole
and connect to the water supplies. The flexi
tails are marked red for hot and blue for cold.
5. Secure the fixing base to the floor using the
fixing supplied.
6. Screw the mixer body onto the fixing base
and push the plinth down to cover the base.
7. Connect the hose to the hose outlet and fit
the handset to the hose using the small
washers.
8. Turn on both water supplies. Operate the
handle in both directions, letting the water flow
for a few minutes.
9. Check all joins and connections for any leaks,
before finishing the floor work.
10. Operate the mixer in both, bath and shower
mode. To switch from bath to shower mode,
pull and then twist the diverter.
To revert back to bath fill, turn the diverter
back.
Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.
11