Decagon Devices EM50G Mulai Cepat
Jelajahi secara online atau unduh pdf Mulai Cepat untuk Pencatat Data Decagon Devices EM50G. Decagon Devices EM50G 2 halaman. Using with a user supplied sim
Juga untuk Decagon Devices EM50G: Panduan Memulai Cepat (2 halaman), Manual (4 halaman), Panduan Memulai Cepat (2 halaman)
Halaman Cetak
Test Buttons
The Em50G has a test button and two indicator LEDs above the batteries
for basic functionality testing.
OK
• When you push the "TEST" button on the logger, both the
"ERROR" (red) and "OK" (green) lights will slowly blink on
ERROR
and off indicating that the testing is in progress.
• When the Em50G is sending data to Decagon's server, the
OK
"OK" (green) light will blink rapidly.
• At the end of the testing, if everything is working properly, the
ERROR
"OK" (green) light will remain lit for approximately 20 seconds.
OK
• If you have pressed the "TEST" button and the bottom red
light remains lit, a communication error is occurring. Perform
ERROR
a telemetry test to attempt to diagnose the problem.
If you have any questions about configuring your Em50G or down-
loading data from the Decagon server, please contact Decagon at
509-332-5600 or [email protected].
13973 | 16-12-15
2365 NE Hopkins Court
Pullman, Washington 99163
tel: 509-332-5600
©2015 Decagon Devices,
Inc.
Em50G/Em50G Solar
Quick Start
About the Em50G
Thank you for purchasing an Em50G data logger. The Em50G is a data
collection device that will allow you to collect and store data from up
to five Decagon sensors. Collected data are sent to the Decagon Data
Service using cellular/mobile communication up to six times a day. You
can access your data from the Decagon Data Service at any time with
DataTrac 3 or at em50gwebviewer.com.
The Em50G is configured using ECH2O Utility or DataTrac 3. DataTrac
3 is the preferred software package for the Em50G and will be the
primary reference throughout this quickstart guide. To utilize ECH2O
Utility or the Em50G webviewer, please consult the Em50G user manual.
Installing the software
Before taking the Em50G into the field, install DataTrac 3 on
your field designated computer.
1. Insert your DataTrac 3 installation USB into your computer
or visit
www.decagon.com/datatrac3
on your computer.
2. Click "Run" to start the installer and follow the onscreen
instructions.
Note: The one year service plan activates when Decagon ships the
instrument and not at time of installation.
to install Datatrac3
]