Bristan K SNKSL EF C Panduan Petunjuk Instalasi - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Produk Pipa Bristan K SNKSL EF C. Bristan K SNKSL EF C 16 halaman. Colonial single lever easyfit sink mixer

Halaman Cetak

Installation Cont.

3. Attach flexible connecting pipes.

Important: Before connecting the flexible

connecting pipes, please refer to the specific

installation requirements on page 6

Carefully screw the 'flexible connecting pipes' into

the 'push-fit connectors'. Fit the isolation valves

(supplied) to the flexible connection pipes and turn to

the 'closed' position as shown on page 6

Note: A flexible connecting pipe can be fed up

through the hot connector hole and then screwed on

if required.

Important: Only tighten the flexible connecting

pipe by hand. Do not overtighten. Connect the

isolation valves/flexible connecting pipes to the

household water supply pipes.

4. Cover cap

If required place the cover cap over the push-fit

connector until the tap body is ready to be fitted.

5. Fit the tap body

Remove the cover cap and place the plinth over the

push-fit connector. Grease the push-fit connector

using the sachet of grease provided. Push-fit

the tap body onto the connector. Align the body and

tighten the grub screw at the rear of the body, using

the long end of the 2.5mm hexagonal key as shown

below until finger tight. Remove the hexagonal key

and insert the short end into the grub screw and

tighten an extra ¾ to 1 complete turn more to ensure

the tap body is securely tightened to the push-fit

connector.

Important: The fitting must be securely attached

to the base.

Turn on the mains water supply and open the

isolating valves using a suitable flat blade

screwdriver. (See page 6)

Need help? Give us a call on 0844 701 6273 and speak to one of our trained advisers.

Hot

connector

2.5mm

hexagonal key

Tap body may vary to the one shown

here

Flexible

connecting

pipes

Cover cap