Majestic Portofino Panduan Instalasi - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perlengkapan Kamar Mandi Majestic Portofino. Majestic Portofino 14 halaman. 17- or 24-mm surface wall profiles
Juga untuk Majestic Portofino: Panduan Instalasi (14 halaman)

Halaman Cetak
Portofino Installation Guide
Insert two short pieces of self adhesive rubber strip into
17
each In Line panel hinge slot as shown. Disassemble the
hinges and place the hinges and their face plates either
side of the hinge slots on the In Line panel, with gaskets
inserted and screws facing inwards. Loosely screw the
hinges and face plates together.
NOTE: Steps 18-19 require one person to support the
door at all times whilst another person must be inside
the enclosure with face plates, gaskets and screws.
DOOR
Rubber
packing
strips
5mm gap
between glass
Position the hinges centrally in their slots and use a set
19
square to ensure that they are at 90 degrees to the
edge of the glass. With gaskets inserted on both sides,
loosely screw the hinges and face plates together
through the glass.
Make any fine adjustment to the alignment of the door
and then fully tighten the hinges to 10-12 Nm torque
and remove the mounting blocks.
The Majestic Shower Company Limited
17 Flitch Industrial Estate, Chelmsford Road,
Dunmow, CM6 1XJ
IN LINE PANEL
strips
IN LINE PANEL
Rubber
packing
strips
Hinge with both
face plates removed
for illustration
purposes only.
Insert two short pieces of self adhesive rubber strip in
18
each door hinge slot as shown.
Position the door mounting blocks in the underframe
channel as shown and lift the door on to the blocks.
It may be advisable to fit the vertical seal to the In Line
panel opposite the hinged panel to protect the glass
from damage when fitting the door.
On the handle side of the Door, fit the vertical seal
20
full height to the edge of the Return panel. Cut
off any excess at the top.
Telephone (0)1279 443644
www.majesticshowers.com
Page 9
Rubber