IKEA ENHET Panduan Instalasi - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Instalasi untuk Perabotan Dalam Ruangan IKEA ENHET. IKEA ENHET 16 halaman. Kitchen
Juga untuk IKEA ENHET: Panduan Instalasi (10 halaman), Panduan Instalasi (20 halaman)

Halaman Cetak

Use a spirit level to find the highest point of the

floor and mark where that is on the wall. This will

be the reference point from which to measure when

marking the key measurements (see below).

Marking key measurements

There are some critical measurements you need to consider and mark on your walls in order to secure proper

alignment, leave adequate room for your work area and follow appliances requirements. Remember to consider

the space needed for doors and drawers to open properly, making sure there are no collisions with radiators

or window sills as drawers and doors are opened.

1. First mark 125mm from the highest point (A) you

found at the very beginning and trace a horizontal

level line across your wall where the cabinets will

be placed. This base line represents the height of

the cabinet legs.

2. Then mark 878mm from the floor and proceed as

before. This is where the top of your base cabinets

will end up.

Prepare your space by making sure your corners are

even and your walls and floor are straight. Use your

try square for the corners and a spirit level for the

walls and floor.

3. Finally, mark another line at 1466mm from the

floor and trace a horizontal line as with the other

markings. This line represents the bottom position

of the wall cabinets and frames.

4. With the lines marked, double-check that your

plumbing and electrical outlets fit the layout plan.

5. Pay attention to the required minimum distance

between cooktop and rangehood. This can be

found in the rangehood assembly instructions.

If your corner and/or walls aren't straight you may

need to use distancers to make sure your kitchen

cabinets and frames become level and align properly.

For advice contact you local specialised dealer.

6. The dishwasher should only be installed between

two cabinets or at least between a cabinet and

the wall. This is needed to secure the appliance

properly and provide support for the benchtop.

7. If you have a kitchen with a corner, you build

the corner base solution with a regular 80cm

base cabinet and an ENHET corner panel.

For the positioning of this solution, see page 8.