Bristan W BTH PU1 C/G Petunjuk Pemasangan & Daftar Isi - Halaman 2
Jelajahi secara online atau unduh pdf Petunjuk Pemasangan & Daftar Isi untuk Produk Pipa Bristan W BTH PU1 C/G. Bristan W BTH PU1 C/G 2 halaman. Bath pop-up wastes
Halaman CetakINSTALLATION
1. Identify all components and check for completeness.
2. Fit the waste body (7) and flange (5) to the bath securing using screw (4);
ensuring sealing washer (6) is placed through the bath before this
is done as shown in the diagram. Use a pure silicon sealant where necessary.
3. Fit the overflow elbow (14) to the bath ensuring overflow washer (15) and seal
(16) are in place, secure with overflow flange (17). Use a pure silicon sealant
where necessary.
4.
Connect flexible tube (12) to the overflow elbow (14) ensuring o-rings (13) are
fitted.
5. Connect the flexible tube (12) to the overflow connection and mark off the
length required against the waste body. Trim the flexible tube as required.
6.
Connect flexible tube (12) to the waste body (7) using the plastic nut (11) and
washers (8, 9, and 10) fitted in the correct order as shown.
7.
Push the handle (18) onto the control spindle, ensuring the grub screw lines up
with the mark on the control spindle
will ensure sufficient gap between the handle and flange.
8.
Check all joints and connections for leaks.
9. See back page for aftercare instructions.
COMPONENTS
1. Plug
2. Adjusting nut
3. Adjusting screw
4. Flange screw
5. Washer flange
6. Flange/body sealing washer
7. Waste body
8. O-ring
9. Conical washer
www.qssuplies.co.uk
(see illustration across the page).
10. Nylon washer
11. Plastic nut
12. Flexible tube
13. O-rings
14. Overflow elbow
15. Overflow washer
16. Seal
17. Overflow flange
18. Handle
.
15
This
PLEASE NOTE:
THE SPINDLE (RINGED) OF THE OVERFLOW ELBOW (14),
AS THIS WILL STOP WATER COMING OUT OF THE
OVERFLOW.
THERE IS A GRUB SCREW IN THE HANDLE THAT WILL
LOCATE IN A HOLE ON THE SPINDLE.
17
16
14
13
BATH
9
8
10
11
12
DO NOT PUSH THE HANDLE (18) ONTO
18
1
2
3
4
5
6
7