AIRFLO AFI01 Buku Petunjuk - Halaman 4

Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pembuat Es AIRFLO AFI01. AIRFLO AFI01 5 halaman.

STEP 2. Connect the plug to the main power switch.

STEP 3. Select desired ice cube size by pressing 'SELECT'

Note: Select the (S) when ambient temperature is below 15°c. When the ambient

temperature is higher than 30°C, large ice cube sizes are recommended.

STEP 4. Press 'START' button to switch unit on. The ice maker begins to work.

STEP 5. If indicator 'DEFICIENT' is red accompanied with a beeping noise, take out the basket then add water

as per step 1.

STEP 6. If indicator 'ICEFULL' is in red with a beeping noise, scoop out the ice.

Note: When the ice collecting tray is full, remove the ice immediately. Do not allow

the ice collecting tray to overfill.

You must press 'STOP' then the 'START' button to restart the Ice Maker after you add water

or remove some of the ice.

STEP 7. Press 'STOP' button to stop the machine.

STEP 8. Remove the drain plug to drain remaining water from the water reservoir. Screw the drain plug back in

place after the water has been drained.

CARE AND MAINTENANCE



Clean the inner liner, ice collecting tray, water box, ice shovel and evaporator frequently. When cleaning,

unplug the unit and remove the ice cubes. Use a diluted solution of water and vinegar to clean the inside

and outside surface of the Ice Maker. Do not spray Ice Maker with chemicals or other diluted cleaning

agents. Rinse thoroughly before starting.



Keep ventilation openings in the appliance enclosure or in the built-in structure clear of obstruction. Do not use

any mechanical device or other means to accelerate the defrosting process.



If the Ice Maker is reused after a long time in storage, the water pump may not pump sufficient water due

to an air block (the deficient water indicator switches on in this case). To correct this, press the START

button again. The Ice Maker will then work normally.



To ensure the cleanliness of the ice cubes, water in the water reservoir should be replaced every 24

hours.



If the compressor stops for reasons such as water shortage, too much ice, the appliance switched off, etc.,

do not restart the system right away. Wait 3 minutes before restarting the Ice Maker.



Always use fresh water before starting ice production either at initial installation or after a long shut-off

period.

1. Please note, if a power failure occurs due to disconnection of the power cord or the off power button has

been pushed accidentally during an ice-making cycle, small ice chips may form and lodge in the automatic

shovel causing it to jam. If this occurs, the ice chips may be removed by disconnecting the power cord and

gently pushing the shovel to the rear of the cabinet and removing the ice chips then restarting the appliance.

2. Restart the ice maker by pressing Stop and then Start. If the ice shovel does not push the ice into the ice

collector, check to see if the water tray is horizontal or balanced. If not then adjust by pressing the ice shovel

lightly with your finger. Then restart the Ice Maker.