AIRFLO ZB-250 Buku Petunjuk - Halaman 4
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Pembuat Es AIRFLO ZB-250. AIRFLO ZB-250 9 halaman.
Halaman Cetak
Before/First Use of Your Ice Maker
1. When transporting, the incline angle of the cabinet should not be over 45 degrees. Do not
turn the Ice Maker upside down as this may damage the compressor and sealed system.
2. Remove all packing material and carefully check your Ice Maker to ensure it is in good
condition and that there is no damage to the Ice Maker or power cord and plug.
3.
The Ice Maker should be placed horizontally on a level surface. To ensure proper ventilation
for your Ice Maker, allow 150 mm of space at the top, the back and on each side of the product.
Do not install the Ice Maker near an oven, radiator, or any other heat source.
4.
After finally positioning the product, wait for 2 hours (keeping the front lid open) before using
the Ice Maker for the first time.
5. Ensure that the voltage indicated on the Ice Maker corresponds with the voltage in your
home.
Safety Notes
Position the Ice Maker on a flat, stable surface.
This Ice Maker can only be used indoors.
The installation and any repairs of the Ice Maker should be performed by a qualified
technician.
Do not use if the power cord is damaged. It must be replaced by a qualified person to
avoid any hazard.
Do not immerse this product in water.
Do not cover this appliance when in operation.
Never tilt the appliance more than 45 degrees.
Only use drinking or potable water with this appliance.
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by a
person responsible for their safety.
Children should not play with the appliance.
Keep all packaging material away from children and pets.
Do not store explosive substances such as aerosol cans with a flammable propellant in
this appliance.
Warning: Keep all ventilation openings clear of obstruction. Unit should not be boxed in
without adequate ventilation.
Warning: Do not use mechanical devices or other means to accelerate the defrosting
process.
It is normal for the compressor and condenser surface to reach temperatures between
70°C and 90°C during operation. Surrounding areas may be very hot.
Due to fast freezing, ice cubes may appear "cloudy". This is air trapped in the water
and will not affect quality or taste of ice.
- 4 -