Decatur Electronics Genesis VP Directional Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Radar Decatur Electronics Genesis VP Directional. Decatur Electronics Genesis VP Directional 19 halaman.
Halaman Cetak
3.1 Primary Menu
You can use the factory default settings listed on the next page or
you can select your own settings To select a setting, repeatedly press
the MENU button until the setting you want to change appears
Then press the select (SEL) button to advance through the selections
for that setting When you have made your selection, release the
buttons and your new settings will be in efect If neither MENU or
SEL is pressed after 2 seconds, the radar gun will return to normal
operating mode Table 3 1 show the primary menu setting choices
Primary menu settings
16
Figure 3.1
25/Aug/2010
DIRECTION (dir): Direction lets you select the direction of the motor
vehicle you want to display The dir default value t A indicates that
you are monitoring motor vehicles moving both toward and away
from the radar gun
BACKLIgHT (bL): This turns on and of the LCD backlight bL ON is
the default setting
AUDIO (Aud): The Audio setting controls the volume level of
the Doppler tone The volume level settings are from 3 to 6 (3 is
minimum and 6 is the highest volume level )
• Previous versions may have a volume range of 0 to 6.
For evidentiary reasons, it is recommended that the
audio level never be muted during normal operation
SENSITIVITY LEVEL (SEn): The SEn option lets you control the
maximum target-acquisition range SEn levels range from 0 through
5 (0 is of, 1 is the minimum range, and 5 is the maximum range )
SQUELCH (SLh): The squelch determines the type of Doppler audio
you want the radar gun to send out When squelch is on, the sound
is only the Doppler tone for the displayed target When squelch is of,
you will hear all Doppler tones, including other vehicles, interference
and any noise the antenna receives
3.2 Secondary Menu
You can use the factory default settings listed on the next page
or set your own To select the secondary menu settings, press and
hold the select (SEL) button, then press the MENU button To select
a setting, press and release the MENU button until the setting you
want to change appears Then press and release the SEL button to
advance through that setting's options When you have made your
selection(s), release the buttons and the new settings will be in efect
If neither MENU or SEL is pressed after 2 seconds, the radar gun will
return to normal operating mode
25/Aug/2010
17