Bristan Opac TS1503 Petunjuk Instalasi dan Panduan Pengguna - Halaman 4

Jelajahi secara online atau unduh pdf Petunjuk Instalasi dan Panduan Pengguna untuk Unit Kontrol Bristan Opac TS1503. Bristan Opac TS1503 20 halaman. Thermostatic shower valves

Halaman Cetak

Specification

Inlet Connections: 15mm compression
connections.
OP TS1503 SCL C – 125-132mm adjustable
centres.
TS1503ECP-2000-MK - 138-145mm
adjustable centres.
Outlet Connections: Top or bottom G ½"
BSP male, 15mm compression adaptor.
Operating Pressure Range:
Min: 0.1 bar – Max: 5.0 bar
Maximum recommended imbalance
between hot and cold supply should not
exceed a ratio of 5:1.
Maximum Static Pressure: 10.0 bar
Maximum Outlet Temperature: Factory
pre-set to 43°C (can be re-set to suit site
conditions). If the temperature is re-set
to suit different site conditions the valve
will work adequately however the TMV3
scheme will not apply.
TMV Type 3 Designation:
HP-SE; LP-S
Need help? Give us a call on 0330 026 6273 and speak to one of our trained advisors.
4
Supply Requirements:
Minimum cold water
supply temperature: 5°C.
Maximum cold water
supply temperature: 25°C.
Maximum hot water
supply temperature: 80°C.
(a maximum hot water supply
temperature of 60 – 80°C is
recommended for ablutionary purposes).
Note: The inlet hot water temperature
must be at least 10°C above the
required blend temperature (e.g. shower
temperature 43°C: minimum hot supply
53°C.
These showers are designed to be used
in conjunction with the kit supplied, or
Bristan shower kits where not supplied.
We cannot guarantee compatability or
adequate performance when used with
other kits. This would also invalidate your
guarantee. Please refer to the installation
manual supplied with your Bristan
shower kits for their specification
information.
This shower valve must be installed
in compliance with current water
regulations. If you have any doubts
about the water regulation requirements
contact your local water services
provider or use the services of a
professional plumber.