Majestic fireplaces PVS-1 Panduan Pemasangan & Pengoperasian Pemilik Rumah - Halaman 6
Jelajahi secara online atau unduh pdf Panduan Pemasangan & Pengoperasian Pemilik Rumah untuk Kipas angin Majestic fireplaces PVS-1. Majestic fireplaces PVS-1 12 halaman. Power venting system for use with decorative gas appliance models: nvc33vn/vp, nvc36vn/vp, nvc39vn/vp, nvc43vn/vp
Halaman Cetak
Majestic
Fireplaces Power Venting System
®
Fig. 5 An 18" (457mm) minimum vertical rise is necessary
before a 90° elbow.
FP1421
Min. vertical rise
11/25/03 djt
Incorrect
Fig. 6 Vent pipe transitions should be gradually tapered.
Power Venter
FP1423
Negative Pressure
pipe transitions
11/25/03 djt
Fig. 7 Vent pipe connections and all joints on the outlet side
of the power venter must be sealed with high temperature
sealant.
FP1422
pipe transitions
Installation
11/25/03 djt
1. Cut 6¹⁄₄" (159mm) diameter hole through outside wall
- see General Code Requirements for proper loca-
tion.
2. Install vent terminal. Fasten from outside with four
(4) screws and caulk around flange edge.
3. Locate fireplace and fasten to floor as shown in fire-
place manual.
6
18" (457mm)
Minimum
FP1421
Correct
FP1423
Positive Pressure
All seams on the
positive side of
power venter to
be sealed with
high temperature
silicone sealant.
FP1422
4. Install optional sound reducer (Model SR5 or SR4)
onto fireplace. See Installation Instructions pack-
aged with sound reducer.
5. Mount Power Venter
NOTE: It is best to locate the fan near the vent
terminal. However, if such a location is not suitable,
the fan can be installed anywhere within the vent
system.
a. Remove vibration isolation mount and retain
the nut from the parts bag and install. Install on
Power Venter as shown in diagram. Next install
flexible duct piece and outlet collar using four (4)
screws to fasten.
b. To prevent vibration, securely support Power
Venter from ceiling or joist with Power Venter
bracket. (Fig. 8)
c. By using 1" (25 mm) bracket, clearance to fan is
maintained at 1" (25 mm). The addition of the 6"
(152 mm) bracket, maintains a 6" (152 mm) clear-
ance to combustibles.
Vertical Mounting
Ceiling
6" (152 mm)
Bracket
1" (25 mm)
Bracket
Vibration
Isolation
Mounts
Fan
FP1424
Horizontal Mounting
FP1424
vertical mounting
Wall or
11/25/03 djt
Wall
Studs
FP1425
Fig. 8 Power venter mounting options.
Power Venter
Bracket
Discharge
Power Venter
Discharge
Fan
Power Venter Bracket
FP1425
horizontal mounting
11/25/03 djt
51810