DecExpert IF-1330 Panduan Memulai Cepat - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Memulai Cepat untuk Perapian Dalam Ruangan DecExpert IF-1330. DecExpert IF-1330 17 halaman.

Halaman Cetak

Troubleshooting

DISCONNECTED THE APPLIANCE COMPLETELY AND LET COOL PRIOR TO ANY SERVICE.

ONLY A QUALIFIED SEVICE PERSON SHOULD SERVICE AND PEPAIR THIS ELECTRIC APPLAINCE.

Problem

1. Fireplace turns off

and will not turn on.

2. Flame is not moving.

3 Flame is not visible.

4 Log set and /or is not glowing.

5 Remote control

does not work.

WARNING

Possible Cause

1. Fireplace has overheated

and safety devise has caused

thermal switch to disconnect

or home circuit breaker has opened.

1. Loose wiring.

2. Flame motor defective.

3. Flame rod out of place

1. Wiring is loose

2. Ember is off mode

1. Low batteries.

2. Not aiming control correctly.

3. Defective remote control and /or

sensor

MADE IN CHINA

Solution

1. Reset switch by turning main

power off and waiting turning it

back on or breaker circuit breaker.

1. Inspect

wiring

connections.

2. Call

qualified

technician to replace flame motor.

3. "Flame Rod" out of place due to

rough

transit/handing

product. This issue can be corrected

as simple as removing the glass,

flipping the fireplace upside and

down, removing a set of screws

that are holding the bottom frame

plate and placing the flame rod

back into place.

1. Disconnect from power source

and

inspect

wiring

connections and repair or replace if

necessary.

2. Push the flame button to high

1. Disconnect from power source

and

inspect

wiring

connections and repair or replace if

necessary.

1. Replace

batteries

control.

2. Aim control at sensor located

directly behind glass screen in

center of unit just above logs.

3. Replace remote control and/or

sensor.

for

loose

service

the

for

loose

for

loose

remote