Gamma 6002 Panduan Pemilik - Halaman 10

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma 6002. Gamma 6002 20 halaman.

MOUNTING THE FRAME

Height Adjustment

The turntable height of the GAMMA 6002 can

be adjusted to suit the stringer. To adjust,

loosen the two set screws on the lower col-

umn support post below the bellows assem-

bly. Adjust the amount of engagement be-

tween the upper and lower column supports

until the desired height is attained. Make sure

that the tension track is still aligned with the

long leg of the base and tighten the two set

screws to lock the upper support column into

place.

Adjusting the Frame Support Posts

Place the racquet frame over the center

support slide and onto the frame support.

Loosen the lever lock bolt on one support

post. Slide the post outward until the center

support of the racquet support slide is posi-

tioned near the inside surface of the racquet

frame. Securely tighten the lever lock bolt.

Adjust the opposite post using the same

procedure.

Caution: To avoid racquet damage, the sup-

port slide should not contact the racquet prior

to fixing the support posts.

Shoulder Support Adjustment

The shoulder supports on the GAMMA 6002

are adjustable to provide support to the

racquet frame. Loosen the knurled knob at

the bottom of the shoulder support and swivel

the support so that the pads will contact the

frame squarely when the arms are closed

against the racquet. Should the shoulder

supports block string holes, adjust the posi-

tion of the racquet between the arms until the

shoulder supports contact the racquet be-

tween grommet holes.