Gamma Progression Els Panduan Pemilik - Halaman 14

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma Progression Els. Gamma Progression Els 19 halaman.
Juga untuk Gamma Progression Els: Panduan Pemilik (20 halaman), Panduan Pemilik (20 halaman)

Halaman Cetak

1. Maintenance & Adjustments

MAINTENANCE & ADJUSTMENTS

counter clockwise to open the gap between the jaws. The clamp jaws should be cleaned

periodically to be free from dirt, oil, and any string coating for them to grip properly. Knife

sharpening stones are excellent for removing build-up on the diamond coated surfaces and

are available.

Note: The string clamps supplied with your stringing machine can accomodate tight string

patterns such as badminton. Depending on the string pattern, the clamp may spread the

strings slightly which will not compromise the quality of the string job. String clamps designed

specifically for badminton racquets are available.

Adjusting the String Clamp Jaw Spacing

The string clamps will need minor adjustments according

to what string type, construction, and gauge you are

using.

To adjust the gap (clamping pressure) between the clamp

jaws, insert the string through the racquet as if you were

beginning the main strings. Clamp the strings and pull

tension. If the string slips through the jaws of the clamp,

tighten the clamp by compressing the clamp jaws to-

gether by hand while turning the Adjustment Knob, in the

Adjustment

clockwise direction. If the clamp leaves impressions or

Knob

damages the string, it may be excessively tight and

should be adjusted by turning the Adjustment Knob

Clamp Base Locking Nut Adjustment

In the event the Locking Lever rotation is

insufficient to ensure smooth operation of

the clamp base, very minor adjustments to

the Clamp Base Locking Nut can be made

with the supplied 17mm socket. Tighten or

loosen the locking nut in very small incre-

ments to provide more clamping pressure or

running clearance as needed.

Quick Action Clamp Base Removal

Quick Action clamp bases can be removed

from the turntable for maintenance or clean-

ing by removing clamp stop located at the

end of the slot in the turntable. To remove the

clamp stop, remove the two screws holding

the clamp stop in place from the underside of

the turntable. Lift the clamp stop out of the

slot, slide the clamp base to the end of the

slot and lift it out. Replace the clamp base

and clamp stop in reverse order.