Gamma PROGRESSION ST Panduan Pemilik - Halaman 11

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma PROGRESSION ST. Gamma PROGRESSION ST 19 halaman.

MAINTENANCE

Tension Calibration Procedure - Step 1

Set the tension to 60 lbs. as indicated by the

linear scale and rotary knob. Place the string

on one end of a tension calibrator into a string

clamp and secure. Place string located on

the other end of the calibrator into the string

tensioner and apply tension. If the brake

lever releases before 60 lbs. or after 60 lbs.,

the tension head should be calibrated as

follows.

Tension Calibration Procedure - Step 2

Loosen the plastic locking screw located on

the side of the latching block as shown. The

plastic screw is used to hold the adjustment

screw in place.

Tension Calibration Procedure - Step 3

If the lever releases before 60 lbs., turn the

adjustment screw located on the left side of

the latch block counter-clockwise to increase

the engagement of the brake release latch

with the brake lever. Repeat step 1 and

adjust until the correct tension is indicated on

the calibrator.

If the tension indicated in step 1 is greater

than 60 lbs., turn the adjustment screw clock-

wise to reduce the engagement of the brake

release latch with the brake lever. Repeat

step 1 and adjust until the correct tension is

indicated on the calibrator.