Gamma Progression STII Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma Progression STII. Gamma Progression STII 19 halaman.

ASSEMBLY INSTRUCTIONS

Remove and Discard Plastic Washers

Turntable Installation

To install the turntable remove the four nuts

underneath holding the mounting bolts in

place. Position the turntable over the turn-

table pin and align the bolts with the holes in

the flange. Secure them with the included

allen wrench.

Note: When purchased with the optional

floor stand, it is most convenient to attach

the base to the floor stand at this point. See

instructions provided with the optional floor

stand.

Support Post Installation

To install the support posts you must first

remove the mounting bolt from the mounting

plate that sets inside the central cavity of the

turntable. There are large holes stamped on

the underside of the turntable that allow you

to support the mounting plate with your fin-

gers while removing the mounting bolt.

After removing the mounting bolt, remove

and discard the plastic washers that are

installed for shipping purposes.

Support Post Installation (cont'd)

Place the support post onto the central slot

of the turntable. With your fingers placed

through the large hole in the underside of the

turntable, press the mounting plate against

the inside top surface of the turntable while

aligning the hole in the support post with the

hole in the mounting plate and fix them with

the mounting bolt. Repeat procedure on to

attach the support post on the opposite side