Gamma X-6 Panduan Pemilik - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma X-6. Gamma X-6 15 halaman.
Juga untuk Gamma X-6: Panduan Pemilik (16 halaman)

Halaman Cetak

ASSEMBLY INSTRUCTIONS

Winder Support Stand Installation

Remove the M5 bolts from the 2 brackets

located in the rear slots of the machine base

using the 5MM hex key. Slide the brackets to

the right end of the base and position the

winder stand over the brackets aligning the

holes in the base of the winder stand with the

holes in the brackets. Attach the winder

support stand using the M5 bolts. Install all 4

bolts loosely at first and then tighten all

securely.

Engaging the Drop Weight Bar Stop

The stringing machine is shipped with the

drop weight bar in the horizontal position. To

limit the rotation of the drop weight bar and

prevent racquet damage during stringing,

the bar stop must be engaged.

Hold the drop weight bar in the vertical

position as shown while turning the 5mm

stop screw located on the back side of the

winder stand clockwise.

Installing the Drop Weight

Remove the endcap from the tension bar

and slide the drop weight onto the bar. The

weight should be oriented with the knob end

closest to the string winder. Replace the end

cap.