Gamma X-6FC Panduan Pemilik - Halaman 12

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma X-6FC. Gamma X-6FC 20 halaman.
Juga untuk Gamma X-6FC: Panduan Pemilik (20 halaman)

Halaman Cetak

STRINGING THE FRAME

Clamping the String

Secure the tensioned main string using

the remaining ﬁ xed clamp. Release the

string from the gripper by raising the ten-

sion arm.

Repeat the procedure for all of the remain-

ing main strings and tie off following the

racquet manufacturers recommendations.

Weaving the Cross Strings

Follow the manufacturer's recommended

stringing pattern for one or two piece stringing.

This will determine the starting point for the

cross strings. If applicable, tie the ﬁ rst cross

string using an appropriate starting knot.

Weave the cross strings over and under

the main strings being careful to alternate

the weave direction of each consecutive

cross string so as to be opposite of the

previously installed cross string.

Completing the String Job

Once the ﬁ nal cross string is tensioned and

clamped, tie off at the appropriate hole speci-

ﬁ ed by the racquet manufacturer.

Remove the frame from the mounting system

by loosening the shoulder supports and

frame supports.