Gamma X-Stringer Panduan Pemilik - Halaman 16

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma X-Stringer. Gamma X-Stringer 19 halaman.

TROUBLESHOOTING TIPS

PROBLEM

String slips in clamps.

String slips in gripper.

String clamp base slips on turntable.

Tensioner slips on Tensioner Bar

after brake lever is released.

String tension too tight or too loose.

With time and use, the clamping surfaces of your machine may become oily or dirty and

result in string or clamp slippage while stringing. Periodic cleaning of the following parts is

recommended.

String Clamps

Clean the inside gripping surfaces of the string clamp jaws by inserting a cloth or pipe cleaner

soaked with isopropyl alcohol between the jaws and rub back and forth. If the build-up is

excessive, dismantle the string clamp jaws to expose the gripping surfaces by removing the

adjustment screw. Using a small nylon brush, (such as a toothbrush), scrub the inside

surfaces until all debris is removed. Clean the jaws with isopropyl alcohol and re-assemble.

String Clamp Base

Clean the base of the clamps and the top of the turntable with isopropyl alcohol.

String Gripper

Follow the same procedure for cleaning the string clamps.

CARE and CLEANING

SOLUTION

- Adjust gap between jaws.

- Clean clamp jaws.

- Clean gripper jaws.

- Adjust Gripper Jaw Stop Screw

- Adjust Clamp Base Locking Nut.

- Adjust tensioner brake lever

- Clean tensioner brake disc

- Check tension using a tension

calibrator and adjust machine calibra-

tion if necessary