Gamma X-Stringer XLT Panduan Pemilik - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Aksesori Gamma X-Stringer XLT. Gamma X-Stringer XLT 20 halaman. Electronic stringing machine

Halaman Cetak

CONTROL PANEL FUNCTIONS

Tension Index Buttons - Changes

tension setting in +/- 1.0 or +/- 0.1 Lb or

Kg increments. Holding the button down

will scroll the tension setting values up

or down. Tension settings entered with

the tension index buttons are placed into

temporary memory setting "0".

Clear Button - Clears display to enter

a new tension or to reset String Length

Meter measurement.

Test Button & Racquet Strung -

Press once for approximate number of

racquets strung. Press again to return.

Press and hold for 5 seconds and the

machine does an internal diagnostic

check, such as the one performed at

start-up.

Lbs/Kgs Button - Changes tension

display from Lbs to Kgs. Each press

of the button toggles back and forth

between Lbs and Kgs.

Pre-Stretch Function - Pulls string 10%

or 20% over the tension setting (up to 90

lbs / 40.8 kgs), releases the string, and

repulls to the tension setting. Each press

of the button toggles between 10%, 20%

or no pre-stretch.

WARNING! FOR INDOOR USE ONLY.

NEVER OPEN UNIT WITH POWER CONNECTED.

CHILDREN SHOULD NEVER BE PERMITTED TO OPERATE THIS

MACHINE WITHOUT ADULT SUPERVISION.

AND FEATURES

Single Digit (1-9)

Memory LED Display

Three Digit (XX.X) Tension

Setting LED Display

Memory Button - Indexes from 9 preset

tension settings that can be stored in

memory. Settings are retained even if

machine is turned oﬀ . Each press of

the button indexes to the next memory

setting. Memory settings 1-9 must be

entered using the keypad followed by

pressing the "ENT" button.

Enter Button - Saves displayed tension

for Memory setting - when tension is en-

tered using the keypad display ﬂ ashes

until this button is pressed to save the

setting. Also Clears display for String

Length Meter measurements.

Knot Function - Increases pulling ten-

sion by 10% over the setting value (max

90 lbs / 40.8 kgs) for one pull. During the

pull the LED stays lit to indicate the Knot

function is enabled.

Speed Button - Changes pulling speed

of winder from Fast (default) to Medium

to Slow. Slow speed is recommended

for low stretch strings, such as Kevlar.

Each press of the button toggles be-

tween Fast, Medium and Slow speeds.

String Length Meter Button - feature is

currently not available.