Airflow AFLR48 Petunjuk Instalasi

Jelajahi secara online atau unduh pdf Petunjuk Instalasi untuk Kipas angin Airflow AFLR48. Airflow AFLR48 4 halaman. Ceiling sweep fan

Halaman Cetak

Ceiling Sweep Fan

AFLR48

Included with your Fan

A. Motor Assembly

B. Four Blades

C. Three Speed Fan Controller

Hangsure Bracket

IMPORTANT NOTES

1. To ensure proper balance, the blades are a matched set. Do

not mix-up the blades with those from another fan.

2. Transport and transit handling may loosen factory fitted

cables. Please check and secure terminal screws before

installation.

Protecting the Fan

Do not place the motor directly onto a flat surface.

Plastic Nipple

The plastic nipple underneath the motor cannot support the

weight of the motor and may be easily damaged. When working

on the fan, place the motor on the foam packaging with the

nipple located in one of the recesses. This protects the nipple

and the finish.

Thank you for purchasing this Airflow Ceiling Sweep Fan. You can be assured of

trouble free operation for years by installing your ceiling fan carefully and according to these instructions.

Please read all the instructions before commencing, then complete each step in order.

D. Screw Pack

E. Mounting Bracket

F. Instruction Sheet.

Foam

Packaging

Installation Instructions

REGISTERED DESIGN • REGISTERED PATENT

All electrical work must be carried

out by a qualified electrician.

Clearances and Angled Ceilings

Minimum

300mm from

other obstacles.

Blades:

Minimum 2.1m

above floor.

Controlling a Single Fan

This fan has been supplied with a quality Clipsal Three Speed

Controller that is designed to operate a single fan.

OFF

Multiple Fans on a Single Controller

You can control up to eight Airflow Fans using a Clipsal

C-Thru

Electronic Fan Controller (purchased separately).

NOTE: The three speed capacitor controller supplied with each

fan is not suitable for controlling multiple fans.

18.5

Hangsure Mounting

Suitable for pitched ceilings

with a maximum angle of 18.5 o .