KitchenAid 30" (76.2 CM) WALL-MOUNT CANOPY RANGE HOOD Panduan Petunjuk Instalasi - Halaman 2
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kompor KitchenAid 30" (76.2 CM) WALL-MOUNT CANOPY RANGE HOOD. KitchenAid 30" (76.2 CM) WALL-MOUNT CANOPY RANGE HOOD 7 halaman. 30” (76.2cm) sealed burner gas slide-in range with self-cleaning thermal/convection oven
Juga untuk KitchenAid 30" (76.2 CM) WALL-MOUNT CANOPY RANGE HOOD: Panduan Petunjuk Instalasi (20 halaman)
Halaman Cetak
Cabinet opening dimensions
25" (63.5 cm) countertop
(with or without backsplash)
24" (61 cm) base cabinet
island installation:
countertop cutout depth 25" (63.5 cm)
Before you start...
Read electrical and carpentry instructions.
Proper installation
is your responsibility.
A
qualified technician
must install this range.
Make sure you have everything
necessary for
correct installation.
It is the customer's
responsibility
to make sure that the countertop
has been properly prepared and that the
installation
clearances specified on the
model/serial
rating plate are met. The
model/serial
rating plate is located on the frame
behind the storage drawer.
Check location
where range will be installed.
The range should be located for convenient
use
in the kitchen. Recessed installations
must
provide complete enclosure of the sides and
rear of range.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE RANGE IS TO BE INSTALLED MUST
BE SEALED.
Cutout shown
is for a 25-inch (63.5 cm)
countertop with a 24-inch (61 cm) base cabinet.
Cabinet construction:
This appliance is
designed for use in a base cabinet with a depth
of 24 inches (61 cm). The maximum depth for
overhead cabinets is 13 inches (33 cm). For the
minimum vertical clearance between the
cooking surface and the overhead cabinets, see
Note.'***
Overhead cabinets installed at either
side of the appliance must be a minimum of 18
inches (45.7 cm) above the cooking surface.
The minimum horizontal distance between the
overhead cabinets is 30 inches (76.2 cm).
Important: Observe
all governing codes
and ordinances.
Grounded electrical
outlet
is required. See
"Electrical requirements,"
Panel B.
30-3/8" (77.2 cm)
r
opening
width
1
cookto
see
P,
Note
***
Cabinet opening
dimensions
that
are shown must be
used.
Do Not pinch the
power cord between
the range and the
wall.
4" (10.2 cm) min. 4
clearance
to side
wall or other
combustible
material
-
bot
y
&i.2
cm)
,lO"
(25.4 cm)
I
min. required
between
cabinet
opening
and door
or hinge opening.
Do Not seal range to
side cabinets.
36" (91.4 cm)
countertop
height
****
Note: 30" (76.2 cm) min. when
bottom
of wood or metal cabinet
is protected
by not less than 114"
flame retardant
milfboard
covered
with not less than No. 28 MSG
sheet steel, 0.015" (0.4 mm)
stainless
steel, 0.024" (0.6 mm)
aluminum
or 0.020" (0.5 mm)
copper.
36" (91.4 cm) min. clearance
between
the top of the cooking
platform
and the bottom
of an
un rotected
wood or metal
1.
ca met.
Countertop
preparation
WARNING: If the information
in
this manual is not followed
exactly, a fire or explosion may
result causing property
damage, personal injury or
death.
- Do Not store or use gasoline
or other flammable vapors and
liquids in the vicinity of this or
any other appliance.
-WHAT
TO DO IF YOU SMELL
GAS
l
Do Not try to light any
appliance.
l
Do Not touch any electrical
switch; Do Not use any
phone in your building.
l
Immediately call your gas
supplier from a neighbor's
phone. Follow the gas
supplier's instructions.
l
If you cannot reach your gas
supplier, call the fire
department.
- Installation and service must
be performed by a qualified
installer, service agency or the
gas supplier.
Personal Injury Hazard
To eliminate the risk of burns or fire, avoid
installing cabinet storage above the
cooking surface. If cabinets are already
installed, reduce the hazard of reaching
over a heated cooking surface by
installing a range hood.The range hood
should extend a minimum of 5 inches out
from the bottom front of the cabinets.
Reaching over a heated cooking surface
could result in a serious burn or other
personal injury.
Electrical Shock Hazard
It is the customer's responsibility:
*To contact a qualified electrical installer.
*To assure that the electrical installation is
adequate and in conformance with
National Electrical Code, ANWNFPA
70 - latest edition* or CSA Standard
C22.1, Canadian Electrical Code,
Part 1 - latest edition"*, and all local
codes and ordinances.
Failure to do so could result in death or
serious injury.
ides of
ver edges
top
The cooktop sides of the slide-in range fit over
the cutout edge of your countertop.
If you have a square finish (flat) countertop
and the opening width is 30-3/a" (77.2 cm),
no countertop
preparation
is required.
30-3/8"
(77.2 cm)
;ydet"h'ng
/
ormed or tiled
30-7&I"
(78.4 cm)
countertop
trimmed
l/4"
(0.64 cm) back at
front corners
of
countertop
-1
'
opening.
Formed front-edged countertops:
Must have
molded edge shaved flat l/4" (0.64 cm) from
each front corner of opening.
Tile countertops
may need trim cut back
l/4" (0.64 cm) from each front corner and/or
rounded edge flattened.
If countertop opening width is greater than
30-3/8" (77.2
cm),
adjust the l/4" (0.64 cm)
dimension.
Countertop must
be
level.
Place level on
countertop,
first side to side; then front to back.
If countertop
is not level, range will not be level.
Oven must be level for satisfactory
baking
conditions.
Product dimensions
Mobile home installation
The installation of this range must conform to
the Manufactured
Home Construction
and
Safety Standards, Title 24 CFR, Part 3280
(formerly the Federal Standard for Mobile Home
Construction
and Safety, Title 24, HUD, Part
280); or when such standard is not applicable,
the Standard for Manufactured
Homes
Installations
1982 (Manufactured
Home Sites,
Communities
and Setups), ANSI A225.1INFPA
501A*, or with local codes.
In Canada, the installation of this ranae must
conform with the current standards CAN/CSA-
2240 -
latest edition***,
or with local codes.
When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as
long as it conforms to the standards listed
30-718"
(78.4 cm)
cooktop
width
Fr
/A- above.
Note:
The metal chassis of the range MUST be
earth-grounded
in order for the con&o1 panel to
work. If the metal chassis of the range is not
earth-grounded,
NO keypads will operate.
Check with a qualified electrician if you are in
.
;;-~u~$l~;,rJ~Or
doubt as to whether the metal chassis of range
(4-s cm) beyond
24"
is earth-grounded.
(61 cm) base cabinet.
Copies of the standards listed may be obtained from:
*
National
Fire Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
**
American
Gas Association
1515 Wilson
Boulevard
Arlington,
Virginia
22209
***Canadian
Standard
Association
176 Rexdale,
Boulevard
Rexdale
(Toronto),
Ontario
M9W 1 R3
Anti-tip
bracket:
The floor anti-tip
bracket
MUST be
installed.
To install
the anti-ti
shipped
with the range, see F
bracket
anel C and
the anti-tip
bracket
template.
Panel
A