Gamma Sports Els Panduan Pemilik - Halaman 5

Jelajahi secara online atau unduh pdf Panduan Pemilik untuk Mesin Merangkai Gamma Sports Els. Gamma Sports Els 10 halaman.

TROUBLESHOOTING TIPS
PROBLEM
String slips in clamps
String slips in gripper
String clamp base slips on turntable
Electrical system does not function
String tension too tight or too loose
CARE & CLEANING
With time and use, the clamping surfaces of your machine may become oily or dirty and result
in string or clamp slippage while stringing. Periodic cleaning of the String Clamps, String Clamp
Base and String Gripper is recommended. Knife sharpening stones work well for cleaning the
diamond coated string clamping surfaces. Cleaning with a solvent such as isopropyl alcohol
and a mild abrasive tool such as a toothbrush also works well to remove oily or greasy build up.
SOLUTION
- Adjust gap between clamp jaws
- Clean clamp jaws
- Clean gripper jaws
- Make sure string is wrapped over top gripper
prior to inserting between gripper jaws
- Clean bottom of clamp & top of turntable with
alcohol
- Adjust clamp base locking nut
- Check power source
- Check power cord connections
- Check tension using a tension calibrator,
adjust machine calibration if necessary
16
POWER CONNECTION & CONTROLS
A
B
A
D
B
C
Instructions for Power Connection and Controls
CAUTION ! Before connecting to the power supply, check the voltage source that the
machine is being connected to. The acceptable range of input voltages for this ma-
chine is between 100 V and 240 V @ 50 to 60 Hz. If you have any questions regarding
the input voltage supply for your area, please ask your electric utility company.
To install the power cord, insert the female end of the power cord into the AC Adapter and
then insert the female end of the cord from the AC Adapter into the A/C Power Cord Socket
"C" located on the back panel of the tensioner. Plug the male end of the power cord into a
grounded power outlet. When using extension cords, use grounded heavy duty extension
cords rated for 15 AMP service.
To connect the foot pedal switch, insert the male pin at the end of the foot pedal switch cord
into the Foot Pedal Switch Receptacle "B" located on the back panel of the tensioner.
Switch on the machine by pressing the Lighted On-Off Power Switch on the back panel. At
start-up, the LED will display a countdown from "9.0" to "0.0" while the machine performs a
self diagnostics check at start-up.
WARNING!
FOR INDOOR USE ONLY.
NEVER OPEN UNIT WITH POWER CONNECTED.
CHILDREN SHOULD NEVER BE PERMITTED TO OPER-
ATE THIS MACHINE WITHOUT ADULT SUPERVISION.
Front Panel Features
A - String Gripper
B - Tension Switch
C
C - LED Tension Display
Back Panel Features
A -
Lighted Power Switch
B -
Foot Pedal Switch Receptacle
C -
A/C Power Cord Socket
D -
String Length Meter (currently not
available)
5