KitchenAid Gas cooktop Panduan Petunjuk Instalasi - Halaman 7

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kompor KitchenAid Gas cooktop. KitchenAid Gas cooktop 8 halaman.

Halaman Cetak

318" nipple

flexible

connector

3/8" nipple

manual shutoff

valve

piessure

regulator

All connections

must

be wrench-tightened.

Assemble the flexible connector from

the gas supply pipe to the pressure

regulator in order: Manual shutoff

valve, 3/8" nipple, 3/8" adapter, flexible

connector, 3/8" adapter, and 3/8" nipple.

Use pipe-joint compound made for

use with L.P. gas to seal all gas

connections.

If flexible connectors

are used, be certain connectors are not kinked.

shutoff

valve

Open the shutoff valve in the gas

supply line. Wait a few minutes for

gas to move through the gas line.

1131

Use a brush and liquid detergent to

test all gas connections

for leaks.

Bubbles around connections

will

indicate a leak.

If a leak appears, shut off gas valve controls and

adjust connections.

Then check connections

again. NEVER TEST FOR GAS LEAKS WITH A

MATCH OR OTHER FLAME. Clean all detergent

solution from cooktop.

/14.1

Plug the power supply

cord into the

grounded outlet.

Place burner

grates over

burners and caps.

Install control knobs on valve

stems.

Electronic Ignition System -

initial lighting

Cooktop burners use electronic ignitors in place

of standing pilots. When the cooktop control knob

is turned to the "HI" position, the system creates

a spark to light the burner. This sparking

continues until the burner ignites.

each control knob to "HI"

fit

position. The flame should

light within 4 seconds.

If the burners do not light

properly, turn the control

knob to the "OFF" position. Check that the

burner cap is plugged in and that the circuit

breaker or fuse has not blown. Check that the

shutoff valve is in the "ON" position. Check

operation again. If burner does not light at this

point, contact your KitchenAid

dealer for

assistance.

117.1

Check each cooktop burner

for proper flame. The small

inner cone should have a

very distinct blue flame approximately

l/2" long. The outer cone is not as

distinct as the inner cone.

1181

Push in and turn each

. control knob to the "LO" (or simmer)

setting. The "LO" setting of each

burner has been factory set to the lowest setting

available to provide reliable reignition of the

burner. If it does not stay lit on the "LO" setting,

contact your KitchenAid dealer for assistance.

To get the most efficient

use from

your new cooktop,

read your

KitchenAid

Use and Care Guide.

Keep Ins talla tion Instructions

and

Guide close to cooktop

for easy

reference.