Airflow iCON Panduan Instalasi dan Pengoperasian - Halaman 4

Jelajahi secara online atau unduh pdf Panduan Instalasi dan Pengoperasian untuk Kipas angin Airflow iCON. Airflow iCON 9 halaman. Domestic dc fans

Front Cover Removal

UNDO THE RETAINING

SCREW AT THE BOTTOM

EDGE OF COVER USING A

SCREWDRIVER.

The 15S requires a 110mm diameter hole through the wall, lined with a 100mm id (internal

diameter) duct.

The 30S requires a 110mm diameter hole through the wall, counter bored 160mm diameter

to a depth of 75mm. The 110mm hole should be lined with a 100mm id duct.

When surface mounting the 30S, the supplied mounting skirt should be used. The 30S

requires a 110mm diameter hole through the wall lined with a 100mm id duct.

POSSIBLE CABLE

ROUTING

CEILING

When recessing fans in the ceiling, a plywood support (min 18mm thick) should be mounted

between the ceiling joists. Fans should not be fitted to unsupported plaster board.

The front cover has a bayonet type

fitting. To remove, undo the retaining

screw at the bottom edge of the cover

using a screwdriver, then rotate the

cover a few degrees anticlockwise and

remove. To refit, reverse the above

procedure.

Page 4 of 8

DUCT

JOIST

PLYWOOD