ENGLISH
5. Hold the door trim (B) on the top edge of
the door at the two sides and push
inwards to release the clip seal.
2
B
6. Pull the door trim to the front to remove
it.
7. Hold the door glass panels by their top
edge and carefully pull them out one by
one. Start from the top panel. Make sure
the glass slides out of the supports
completely.
8. Clean the glass panels with water and
soap. Dry the glass panels carefully. Do
not clean the glass panels in the
dishwasher.
9. After cleaning, install the glass panels,
the door trim and the oven door, close
the latches on the both hinges.
If the door is installed correctly, you will hear
a click when closing the latches.
Make sure that you put the glass panels (A, B
and C) back in the correct sequence. Check
for the symbol / printing on the side of the
glass panel, each of the glass panels looks
different to make the disassembly and
assembly easier.
The screen-printing zone must face the inner
side of the door. Make sure that after the
installation the surface of the glass panel
frame on the screen-printing zones is not
rough when you touch it.
When installed correctly the door trim clicks.
1
A
B
C
Make sure that you install the middle panel
of glass in the seats correctly.
Replacing the lamp
Put a cloth on the bottom of the interior of
the oven. It prevents damage to the lamp
glass cover and the cavity.
Warning! Danger of
electrocution! Disconnect the fuse
before you replace the lamp.
The lamp and the lamp glass
cover can be hot.
Caution! Always hold the halogen
lamp with a cloth to prevent
grease residue from burning on
the lamp.
1. Turn off the oven.
2. Remove the fuses from the fuse box or
turn off the circuit breaker.
3. Turn the lamp glass cover
counterclockwise to remove it.
4. Clean the glass cover.
5. Replace the oven light bulb with a 40 W,
230 V (50 Hz), 350 °C heat resistant oven
light bulb (connection type: G9).
31
A
B
C
Halaman Cetak