Green Force Diamond 600-AA Panduan Pengguna - Halaman 9
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Senter Green Force Diamond 600-AA. Green Force Diamond 600-AA 17 halaman. Modular lighting systems
Halaman Cetak- 1. Table of Contents
- 2. PWM Technology
- 3. Green Force Hybrid & TOS
- 4. Temperature Protection
- 5. End of Battery Life
- 6. Maintenance of Your Dive Light
- 7. Flexi Battery Packs
- 8. Hybrid Battery Packs
- 9. Using Your Green Force Dive Light
- 10. Controlling the Power
- 11. Green Force Dynamic Power Management
- 12. Green Force Dynamic Beam
- 13. Diamond Backup Light
- 14. Depth Rating & Warranty
Using
your Green Force Dive Light
Your Green Force dive light is equipped with a rotary on/off system. Whether your
Green Force light is connected to a Green Force battery pack or to a Green Force
umbilical, turn the light head clockwise to switch on the light and turn the light
head counter clockwise to switch off the light.
Attention:
-
Regularly check condition of sealing O-rings.
-
Clean and grease the sealing O-rings every time the light head is removed.
switch on
switch on / switch off / switch on : in less than 5 seconds to switch from 100% power mode to 50%power mode
switch off
* not available on Dynamic Power Mode and Dynamic Beam light heads
All Green Force light heads (except for DPM and DB light heads) can be used in
100% and 50% power mode. As the Green Force dive lights have a rotary on/off
system, selecting these 100% and 50% power modes is to be done using the rotary
on/off system.
When switching on the Green Force dive light it will automatically start up in 100%
power mode. In order to activate the 50% power mode, the dive light has to be
switched off and then immediately switched on again within 5 seconds after it has
initially been switched on.
If the dive light has been switched on for more than 5 seconds, it will activate the
100% power mode at the next startup.
9
Controling
the power*
switch on
switch off
switch on