Green Force Flexi Kit 3 in 1 DB Panduan Pengguna - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Senter Green Force Flexi Kit 3 in 1 DB. Green Force Flexi Kit 3 in 1 DB 17 halaman. Modular lighting systems
Halaman Cetak- 1. Table of Contents
- 2. PWM Technology
- 3. Green Force Hybrid & TOS
- 4. Temperature Protection
- 5. End of Battery Life
- 6. Maintenance of Your Dive Light
- 7. Flexi Battery Packs
- 8. Hybrid Battery Packs
- 9. Using Your Green Force Dive Light
- 10. Controlling the Power
- 11. Green Force Dynamic Power Management
- 12. Green Force Dynamic Beam
- 13. Diamond Backup Light
- 14. Depth Rating & Warranty
Temperature
Your Green Force dive light can also be operated out of the water. However, the
microprocessor will reduce the power when the temperature rises and possibly it
will even shut down the light to protect the LEDs from overheating.
End of
At the end of the battery life (when the batteries are discharged) the Green Force
dive light will go into 'Bring Me Home mode' (BMH mode) to protect the batteries
from deep discharge. The light will reduce the power to a level that is sufficient to
monitor your instruments while making a safe ascend. Do not restart the torch while
in BMH mode, this will possibly lead to reduced battery life expectations as it could
bring your rechargeable batteries is a deep discharge state.
Protection
battery life
Maintenance
Green Force dive lights obtain their water tightness by means of durable NBR
O-rings. These O-rings are extremely important and require your special atten-
tion. The O-rings must be maintained with great care, they have to be free of
impurities and cracks and should slightly be greased with silicone grease. The
grease reduces friction and allows the O-ring to settle in it's correct place. Do not
use too much grease as it could accumulate dirt and sand particles and could
lead to water entry. Never use hard or sharp metal tools to remove O-rings, you
could permanently damage the sealing surface or the O-ring itself.
O-rings should be cleaned with a soft cloth that does not shed fluff, and then be
lightly greased with silicone grease. Stretch the O-ring a bit and let it slide be-
tween your fingers to detect any damage. After every use the condition of the O-
rings should be checked. If there is any doubt about the condition, and preferably
after approximately every 200 dives, it is advisable to replace the sealing O-rings.
After each dive, it is highly recommended to rinse your torch externally with fresh
water. While rinsing, make sure that the dive light is sealed with the light head
(and umbilical) connected to the battery pack to prevent the water from entering.
It is recommended to separate the components (light head, umbilical and bat-
tery) of your Green Force dive light when stored for longer periods so the O-rings
of the TOS connection cannot deform permanently.
5
of your dive light