Gan Systems GS-EVB-HB-0650603B-HD Panduan Teknis - Halaman 5
Jelajahi secara online atau unduh pdf Panduan Teknis untuk Beralih Gan Systems GS-EVB-HB-0650603B-HD. Gan Systems GS-EVB-HB-0650603B-HD 18 halaman. Half bridge bipolar drive switch board
Halaman Cetak_____________________________________________________________________________________________________________________
1 Overview
1.1 Introduction
The Integrated Circuits Half Bridge Driver-Switch GS-EVB-HB-0650603B-HD is a demonstration board
containing two HEY1011-L12C GaN FET drivers and two 650V, 60A GaN FETs configured in a half bridge
configuration.
The datasheet for the HEY1011-L12C in this board can be found here.
The GS-EVB-HB-0650603B-HD can be used to perform
an existing
LC power
section, both as shown below.
The isolated HEY1011-L12C driver does not require secondary side power or bootstrap components. Gate
drive power is supplied to secondary side from the primary side supply voltage V
the gate drive can be varied by varying V
1.2 Quick Start Guide
V
DRV
IN_H
1. Apply V
= 12V
DRV
2. Link pins EN_PU and EN (if not using external Enable control)
3. Apply input gate signals, with adequate dead time, to the IN_L and IN_H inputs.
4. Convenient test points a located on the test board as shown above. A suitable differential
oscilloscope should be used to monitor the high side gate signal from V
GS-EVB-HB-0650603B-HD TM Rev. 210712
between 7 V and 15 V.
DRV
LINK
IN_L
Figure 1: GS-EVB-HB-0650603B-HD Quick Start
© 2021 GaN Systems Inc
Please refer to the Evaluation Board/Kit Important Notice on page # 16
GS-EVB-HB-0650603B-HD
Half Bridge Bipolar Drive Switch Board
double pulse
tests, or to interface the half bridge to
to V
GH
Technical Manual
. The amplitude of
DRV
L
V
OUT
BUS
C
OUT
Optional external
decoupling
.
SW
www.gansystems.com
5