Decofire Milano DF102040 Petunjuk Perakitan, Keselamatan & Pengoperasian - Halaman 13

Jelajahi secara online atau unduh pdf Petunjuk Perakitan, Keselamatan & Pengoperasian untuk Perapian Luar Ruangan Decofire Milano DF102040. Decofire Milano DF102040 17 halaman.

Halaman Cetak

IN THE EVENT OF FAULT

Most problems can be easily solved by using the trouble shooting guide below to determine the cause and solution before

calling our customer service team.

Problem

Burner will not light

(Electric starter faults)

Burner will not light

(Gas supply faults)

Burner emits smoke

Sudden drop in gas flow No gas flow / no gas

Burner will not stay

alight / Flame blows out

easily

Cause

Igniter electrode pin and / or burner

are wet

Igniter battery is incorrectly inserted Check which direction the battery is inserted.

Igniter battery is exhausted / dead

Igniter electrode pin is broken

Igniter electrode wire is loose or

disconnected

Electrode wire is shorting between

valve

No gas flow / no gas

Obstructed gas flow

Burner ports obstructed - dirt or

debris

Burner ports obstructed -

Bugs, spiders, webs or nests

Flame obstructed at burner ports

Regulator hose is kinked

No gas flow / no gas

Excess flow or safety shut off device

safety valve has been activated

(If fitted)

Flame obstructed at burner ports

Strong ambient breeze present.

No gas flow / no gas

Solution

Dry off with a soft cloth.

Replace with a fresh 1.5V AAA battery .

Replace the electrode - Contact Décofire.

Reconnect contact wire to the igniter box.

Check for source of short - replace electrode wire if

faulty - Contact Décofire.

Check cylinder valve is turned on.

Cylinder low or empty - refill or swap over cylinder.

Regulator / hose not connected - check all

connections, leak test and resume lighting and

operation procedures.

Check all hoses for kinks and bends.

Turn off appliance flame control and cylinder valve.

Insert an opened paper clip (or similar item) into each

of the burner ports to clear them out.

Turn off appliance flame control and cylinder valve.

Insert an opened paper clip (or similar item) into each

of the burner ports to clear them out.

Use caution when clearing any web or nest.

Check that all burner ports are free of any small

burner media (Lava rock or pumice stone etc).

Check hose and remove any bends or kinks.

Check cylinder valve is turned on / fully open.

Cylinder low or empty - refill or swap over cylinder.

Turn the flame control knob to the 'OFF' position.

Turn off the cylinder valve.

Check for the reason why the safety device has

activated before resetting the safety device. (Follow

the manufacturers instructions). Then turn on the gas

cylinder valve and restart the appliance as per the

lighting procedure in this manual.

Check that all burner ports are free of any small

burner media (Lava rock or pumice stone etc).

Increase flame to 'HIGH'

Check cylinder valve is turned on / fully open.

Cylinder low or empty - refill or swap over cylinder.

Page 13