Gandy 10T Series Panduan Operator - Halaman 6

Jelajahi secara online atau unduh pdf Panduan Operator untuk Penyebar Gandy 10T Series. Gandy 10T Series 10 halaman. Fertilizer spreader
Juga untuk Gandy 10T Series: Panduan Operator (11 halaman)

Halaman Cetak

Operation & Calibration:

1) Observe the important service and safety decals located on the spreader.

N02-0014-010

2) With spreader in the closed position fill hopper and close lids.

Check to see that spread-plates are set at desired angle. Spread plats can be adjusted by changing

how the sash chain is hooked to the spreader. Start with the spread plate at about 45 degrees. This

is a starting point. When using different materials the angle may need to be adjusted up or down to

create a sheet like flow for even coverage. Or the spread-plates can be removed to drop material in

slight streaked rows.

3) Set the Cam-Gauge for the material you are using. The numbers on the Cam-Gauge are for

reference only and have nothing to do with your desired rate. The larger the number the more the

bottom opens or a higher applied rate. The smaller the number the less the bottom opens or a lower

applied rate.

Use the top edge of the stop as the gauge point for the line on the Cam-Gauge.

See rate chart for setting. If the material you are using is not listed pick a material that is close in

size and you will have to calibrate to get the desired rates you want.

4) Before applying make sure to engage the wheel hubs by flipping the levers down and pulling ahead

a little to make sure the wheel hubs engage.

5) Check calibration by one of the two methods described below.

Using the optional Calibration Pans or the know area method.

In conducting rate checks always maintain actual field operation speed.

To check your ground speed use the following chart comparing speed to distance traveled in one

minute.

1 mph

2 mph

88 Ft.

176 Ft.

264 Ft.

6) After checking application rate apply material.

7) Close slide to shut-off material flow and to prevent moisture from entering openings in hopper over

night or when spreader is not in use. Remember to disengage the wheel hubs when traveling to and

from locations.

Continued on Next Page....

3 mph

4 mph

5 mph

352 Ft.

440 Ft.

N02-0014-020

6 mph

7 mph

528 Ft.

616 Ft.

~ 1 ~

N02-0057-000

8 mph

9mph

10 mph

704 Ft.

792 Ft.

880 Ft.