Gantner Q Series Manual - Halaman 5

Jelajahi secara online atau unduh pdf Manual untuk Unit Kontrol Gantner Q Series. Gantner Q Series 17 halaman.

1.4

1.5

1.6

this manual. Electrical connections must only be carried out by specialist

personnel trained for the task.

In particular, pay attention to the following:



The national installation and erection regulations (e.g. ÖVE, VDE, etc.).



Generally accepted engineering rules.



The details on transport, installation, operation, servicing,

maintenance and disposal in this manual.



The parameters, limits and the details about the operating and ambient

conditions on the name-plates and in the data sheets.

Siting locations

The devices in the Q.series range are protected to IP 20 against water, dirt

and small parts. If the ambient conditions require it, the modules can be

fitted in water-protected or watertight housings.

Please note the admissible ambient temperatures specified in the technical

data.

Making modifications to the modules or devices is not permitted. Dirt and

shrouding covers may only be removed for service and maintenance

purposes.

The modules or devices do not need any servicing. Cleaning may only take

place in the voltage-free state. Therefore, follow the points below:



Before cleaning, disconnect all connectors.



Clean the housing with a soft, slightly moistened cloth. Never use any

solvents, because these may attack the labels.



When cleaning, make sure that no liquid enters the device or goes

onto the terminals.

Never attempt to repair nor to again operate devices which are defective,

have developed a fault or are damaged. In this case it is essential to contact

your customer consultant or Gantner Instruments.

Version no. 1.0

Released February 12, 2018