Ganz BC-IR3.6N Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kamera Keamanan Ganz BC-IR3.6N. Ganz BC-IR3.6N 4 halaman. Outdoor ir color camera

INSTALLATION

1. Use the supplied three screws to attach the bracket to wall. Drill a hole in advance on the proper

position of the wall for the Power and Video Cable to pass through later.

2. Remove the Joint Lock from the bracket by turning it counterclockwise. Then, screw the Joint Lock

to the backside of the camera (turn clockwise)*.

* There are two screw holes on the backside of the camera. Please choose the proper one which best

suits your installation environment. If the upper screw hole is chosen, it's recommended to push the

Sun Shield a little bit toward the direction of the lens for easy installation.

Sun Shield

3. Screw the camera with the Joint Lock connected to the bracket. Adjust the camera angle and the

Sun Shield position. After that, secure the Joint Lock to fix. Then, pass the Power and Video Cable

through the hole drilled in Step 1 to hide it.

Power and Video Cable

CONNECTION

1. Video Output Connector (VIDEO OUT)

Connect the camera video output and the monitor

video input with 75Ω coaxial cable.

2. DC12V Input Terminal

Connect the power terminal of the camera to a 12V

DC regulated power supply.

Note: Please use the correct power adaptor, DC12V

(regulated), to operate this unit. The power

tolerance of this unit is DC12V ± 10%. Over

maximum DC 12V power input will damage this unit.

Joint Lock