IKEA IHW7302YS0 Panduan Penggunaan & Perawatan - Halaman 8

Jelajahi secara online atau unduh pdf Panduan Penggunaan & Perawatan untuk Kap Ventilasi IKEA IHW7302YS0. IKEA IHW7302YS0 44 halaman. 30"(76.2cm) wall-mount canopy range hood

Halaman Cetak
INSTALLATION INSTRUCTIONS
•
It is recommended
that the vent system be installed before
8. Mark centers of the fastener locations through the template
hood is installed,
to the wall.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
•
Check your ceiling height and the hood height maximum
before you select your hood.
1. Disconnect
power.
2. Determine which venting method to use: roof, wall, or non-
vented.
3. Select a flat surface for assembling the range hood. Place
covering over that surface.
r
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift range hood onto covered surface.
Range Hood Mounting Screws Installation
5. Determine and mark the centerline on the wall where the
canopy hood will be installed.
6. Select a mounting height between a minimum of
24" (61.0 cm) for an electric cooking surface, a minimum
of 27" (68.6 cm) for a gas cooking surface, and a suggested
maximum of 36" (91.4 cm) above the range to the bottom
of the hood. Mark a reference line on the wall.
7. Tape template in place, aligning the template centerline and
bottom of template with hood bottom line and with the
centerline marked on the wall.
g=
10.
IMPORTANT: All canopy mounting screws must be installed
into wood. If there is no wood to screw into, additional wall
framing supports may be required.
Remove the template.
Drill 3Ad' (4.8 mm) pilot holes at all locations where screws are
being installed into wood.
Install 2 - 5 x 45 mm mounting screws. Leave a 1/4"(6.4 mm)
gap between the wall and the back of the screw head to slide
range hood into place.
(6.4 ram)
_
Vent Cover Support Bracket Assembly and Installation
1. Assemble the 3 pieces of the vent cover bracket using 4 -
4.2 x 8 mm screws provided. The assembled bracket should
be sized to fit inside the upper vent cover.
C
A. Vent cover
bracket
assembly
B. Upper
vent cover
C. 4.2 x 8 mm screws
J
J
D. Centerline
i
j
B
A. Centerline
B. Fastener locations
2=
3.
4.
Position vent cover bracket on wall about 1/8"(3.0 mm) away
from the ceiling.
Mark the hole locations.
Drill 3/8"(9.5 mm) holes for wall anchors and insert anchors
flush with the wall.
C
E I
B_ ;'°
D
A. 8 x 40 mm drywall anchors
B. Centerline on wall
C. Vent cover support bracket
D. 5 x 45 mm screws
E. Centerline of bracket
5. Attach vent cover support bracket to wall.
8