IKEA IHW7303WS0 Panduan Penggunaan dan Perawatan - Halaman 8
Jelajahi secara online atau unduh pdf Panduan Penggunaan dan Perawatan untuk Kap Ventilasi IKEA IHW7303WS0. IKEA IHW7303WS0 32 halaman. 24" (61.0 cm) - 30" (76.2 cm) wall-mount canopy range hood
Halaman Cetak
INSTALLATION INSTRUCTIONS
It is recommended
that the vent system be installed before
hood is installed.
•
Before making cutouts, make sure there is proper clearance
within the ceiling or wall for exhaust vent.
•
Check your ceiling height and the hood height maximum
before you select your hood.
1. Disconnect
power.
2. Determine which venting method to use: roof, wall, or non-
vented.
3. Select a flat surface for assembling the range hood. Place
covering over that surface.
r
Excessive Weight Hazard
Use two or more people to move and install
range hood.
Failure to do so can result in back or other injury.
4. Using 2 or more people, lift range hood onto covering.
Range Hood Mounting
Screws
Installation
Determine and mark the centerline on the wall where the
range hood will be installed.
Select a mounting height between a minimum of
30" (76.2 cm) and a suggested maximum of 36" (91.4 cm),
above the range to the bottom of the hood and mark
reference line on the wall.
NOTE: For installation locations with reduced ceilings
heights, the vent hood may be installed using the upper vent
cover for both vented and non-vented
(recirculating)
installations.
Tape template in place, aligning the template centerline and
bottom of template with hood bottom line and with the
centerline marked on the wall.
=
=,
A
==
O Q
I
0
......
._ ..,__.....
C
C
D
5=
6.
7=
#
8. Mark centers of the 6 fastener locations through the template
to the wall.
IMPORTANT: All screws must be installed into wood.
Remove the template.
9. Drill %4" (2.75 mm) pilot holes at all locations where screws
are being installed into wood.
10. Attach two mounting hooks to the wall at location marked on
the template.
A
B
!i....................
¸¸¸¸¸¸¸/
........
A. Mounting hooks
B. Centerline on wall
Vent Cover Bracket Assembly and Installation
1. Assemble the three pieces of the vent cover bracket using the
four 4 X 8 mm screws provided. The assembled bracket
should be sized to fit inside the upper vent cover.
A
J
J
2=
A. Vent cover bracket assembly
B. Upper vent cover
C. 4 X 8 mm screws
D. Adjustable
width
Position vent cover bracket on wall about 1/8"(3.0 mm) away
from the ceiling.
A. Centerline
B. Mounting hook location
C. Fastener locations
D. Mounting height reference
8