Ganz ZC-D5025NXAT Buku Petunjuk - Halaman 6
Jelajahi secara online atau unduh pdf Buku Petunjuk untuk Kamera Keamanan Ganz ZC-D5025NXAT. Ganz ZC-D5025NXAT 12 halaman. Mini dome camera
Halaman Cetak
Running cables on the exterior surface of the ceiling or wall
To run cables on the exterior surface of the ceiling or wall, use the following
procedure to attach the camera body.
1 Remove the surface mount cover from the camera body.
Hold the body cover and turn
the surface mount cover in a
counter-clockwise direction
until you hear a click.
2 Remove the section on the back side of the camera body and the section of
the surface mount cover indicated in the figures to drill holes through which
the cable needs to be passed.
Bend and remove
this area.
Rear
surface of
the camera
body
3 Attach the surface mount cover to the camera body.
4 Remove the body cover, and attach the camera body to the ceiling or wall.
Pass the cable through the holes you prepared in Step 2 above.
Please use fixing screws suitable for the material of the ceiling or wall when at-
taching the camera body. We recommend using screws with a 4mm diameter.
Pass the cable through here.
Embedding in the ceiling or wall
Be sure to use the adapter ring when embedding the unit in the ceiling or wall.
Drilling holes in the ceiling or wall
1
Use the template included to mark out the position on the ceiling or wall where you
want to install the unit.
Double check to make sure that the sizes and positions of the holes are appropriate
BEFORE drilling the holes.
Attaching the adapter ring
2
Attach the adapter ring to the ceiling or wall to which you
want to attach the camera body.
Attaching the camera body
3
1 Remove the surface mount cover from the camera
Surface mount cover
2 Remove the body cover, Attach the camera body
When you finish attaching the camera, refer to page EG- 7 .
EG-6
Use the template, drill two holes for screws (Screw B) used to attach the adapter
ring. Then, follow the perforations on the template and cut out a hole to embed
the camera body.
Please use fixing screws suitable for the material of the
ceiling or wall when attaching the camera body. We
recommend using screws with a 4mm diameter.
body.
to the adapter ring.
Please use the self-tapping screws included in
the kit. Do not use any other screws.