CEP CT63 Panduan Pengguna - Halaman 2

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Terminal sentuh CEP CT63. CEP CT63 20 halaman.

Important information

This technical description contains important information for start up and use of the CT63 Terminal.

Read it carefully before you start working with the CT63 Terminal.

The warranty will be void should damage occur due to non-compliance with these instructions for use.

We cannot accept any responsibility for consequential loss.

We cannot be held responsible for material loss or personal injury that is due to incompetent use or

non-compliance with the safety instructions. The warranty will be void in such circumstances.

The CT63 Terminal contains highly integrated components which can be damaged by electrostatic

discharge if the user would open the housing.

CEP preserves the right to change the included information without notice and doesn't take

responsibility for errors in the document and/or missing information.

Therefore only touch the CT63 Terminal on the housing or connectors and avoid

touching the components on the board.

When using products which are exposed to electric voltage the valid regulations have to

be observed.

Before opening of a device always pull the mains adapter or make sure that the device is disconnected

from the power supply.

You should only use tools on components, modules or devices if they are disconnected from the power

supply and the electric charge, which may still be stored in some components, inside the device has

been discharged.

All cables and wires which are energized and connected to the device, the module or components have

to be checked regularly for any damage of the isolation shield or fractures of the cables. If the supply

cables are visibly damaged the device has to be taken out of operation immediately until the faulty

cable has been exchanged.

When using components or modules it is necessary to strictly observe the specification given in the

corresponding description of these components. If a description for a private end-customer not clearly

states which electric data is valid for a component or a module, how to wire the device, which external

components or additional devices can be connected or which parameters these components are

allowed to have, a specialist must be contacted.

Before putting a device into operation, it has to be clarified, whether this device or module is meant for

the field of application. In case of doubt ask specialists or the manufacturer of the device.

Please note that we are not responsible for any errors in usage or connection. Therefore we cannot

accept any responsibility for consequential loss.

Devices which operate with >35 Volt have to be connected by a specialist. Before putting the device

into operation it should be checked that there is no current leakage on the housing.