CEPE A6-18C-G Manual - Halaman 7

Jelajahi secara online atau unduh pdf Manual untuk Kompor CEPE A6-18C-G. CEPE A6-18C-G 7 halaman. Commercial induction cooker

2 damage caused by improper operation of non‐transit case and panel damage.

3, apart without warranty does not provide an effective seal off the

4 to 5 times the certificate beyond the warranty period locust

Beyond the warranty period of the product needs repair, please contact CEPE service, we will

repair your product value of the actual cost of materials where appropriate, take charges, the

appropriate site for collection of service charges,

You dial anywhere in China will be CEPE 4008‐898‐788 nearest service for fax, please send it

to 020‐399922282, service to bring complaints hotline 13073081111

Dedicated low‐carbon technology in energy‐saving kitchen

Appliance Co., Ltd, Guangzhou, Sybase

Address: Panyu District, Guangzhou City, Energy Technology Innovation Center Fan

Mountain Park

Tel :4008 ‐898‐788

Fax :020 ‐39,922,282

Caution: The user is cautioned that changes or modifications not expressly approved by

theparty responsible for compliance could void the user's authority to operate the equipment.

Note: This equipment has been tested and found to comply with the limits for Class B ISM

equipment, pursuant to Part 18 of the FCC Rules. These limits are designed to provide

reasonable protection against harmful interference in a residential installation. This

equipment generates, uses, and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful interference to radio

communications. However, there is no guarantee that interference will not occur in a

particular installation. If this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures: ‐

Reorient or relocate the receiving antenna.‐ Increase the separation between the equipment

and receiver. ‐ Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.