Avantco 178APT48MHC Panduan Pengguna - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Pengguna untuk Kulkas Avantco 178APT48MHC. Avantco 178APT48MHC 13 halaman. Commercial refrigerator

Installation

Important!!! Please Read Before Installation

•

If the shelf has a raised lip, the lip needs to be installed facing up towards the rear of the cabinet to promote

proper air flow. Failure to install the shelves properly is considered user-error and is not covered by

warranty.

• If the unit has recently been transported on its side, please let unit stand still for a minimum of 24 hours

before plugging it in.

• Make sure that the unit drops down to desired temperature before loading the unit with product.

• Make sure that there is proper ventilation around the unit in the area where it will operate.

• Make sure all accessories are installed (i.e.. Shelves, shelf clips, casters) before plugging the unit in.

• Please read through the manual in its entirety.

•

Install the unit on strong and leveled surfaces

- Unit may be noisy and/or malfunction if surface is uneven.

•

Install the unit in an indoor, well-ventilated area

-For best performance, please maintain clearance of 4" on the back of the unit. Brackets should be attached on the

back of the unit.

- Outdoor use may cause decreased efficiency and damage to the unit.

• Avoid installation in a high humidity and/or dusty area

- Humidity could cause unit to rust and decrease efficiency of the unit.

- Dust collected on condenser coil will cause unit to malfunction.

- Malfunction due to dirty condenser will void warranty.

•

Select a location away from heat and moisture-generating equipment

- High ambient temperatures will cause the compressor to overwork, leading to higher energy bills and gradual

breakdown of the unit.

-With the lid open, the unit should not be used in areas over 80 degrees. The unit should not be used in areas over 90

degrees.

-Malfunction due to high ambient temperature will void warranty.

•

For optimal performance, 3" of clearance is required around all louvered or vented panels, to allow for

proper air flow

-For your convenience, a set of brackets is included to prevent this unit from being pushed up against a wall

-Component failure due to improper installation is not covered under warranty.

User Manual

- 3 -