KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop Panduan Petunjuk Instalasi - Halaman 3

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kompor KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop. KitchenAid Recreational Vehicle Two-Sealed-Burner Gas Cooktop 8 halaman.

Halaman Cetak
Check location
where cooktop will be installed.
Before you start...
Proper installation
i' your responsibility.
Make
The location should be away from strong draft
sure you have everything
necessary for correct
installation.
It is the responsibility
of the installer
to comply with the installation
clearances
areas, such as windows, doors and strong
specified on the model/serial
rating plate. The
model/serial
rating plate is located on the bottom
heating vents or fans. The cooktop should be
of cooktop.
located for convenient
use in the kitchen.
ALL OPENINGS
IN THE WALL OR FLOOR
WHERE COOKTOP
IS TO BE INSTALLED
MUST BE SEALED.
Grounded
electrical
outlet is required.
See
Electrical requirements.
Do Not obstruct
flow of combustion
and
ventilation
air.
Proper gas supply
connection
must be
available.
See Gas supply requirements.
30" min. base cabinet
is required. If cabinet has
a drawer, a 3-l/2" depth clearance from the
countertop to the top of the drawer (or other
obstruction)
in base cabinet is required.
Product
dimensions
The distance to the front edge of the countertop,
distance to a side wall or other combustible
surface, location of electric supply and height to
cabinets above cooktop are specified on page 2.
Cabinet construction:
This appliance is
designed for use in a base cabinet with a depth
of 24". The maximum depth for the overhead
cabinets is 13". The minimum vertical clearance
between the cooking surface and the overhead
cabinets is 30".
Overhead cabinets installed at either side of the
appliance must be a minimum of 18" above the
cooking surface.
The minimum distance
between the front edge of the countertop and the
front edge of the cook-top is 314". The minimum
horizontal distance between overhead cabinets
above appliances
is 30".
It is the customer's
responsibility:
l
To contact a qualified
electrical
installer.
l
To assure that electrical
installation
is
adequate
and in conformance
with National
Electrical
Code, ANSVNFPA
70 -
latest
edition*,
and all local codes and ordinances
When installing a cooktop under existing cabinets
and the installation does not meet the minimum
cabinet clearances, install a range hood above
Countertop
opening
dimensions
that are
shown must be used. Given dimensions provide
the cook-top to avoid burn hazards.
required clearances.
Important:
Observe all governing
codes and
ordinances.
Failure to meet codes and
ordinances
could lead to fire or electrical
shock.
Copies of the standards
listed may be obtained
from:
* National
Fire Protection
Association
Batterymarch
Park
Quincy,
Massachusetts
02269
Product/cutout
Dimensions
\(
11-15116"
4
backsplash
or rear wall
l-1/2"
min *i&
11" ,\
d
1-W"
min.
I
front edge
of countertop
3