KitchenAid W11179813A Panduan Petunjuk Instalasi - Halaman 18

Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Kompor KitchenAid W11179813A. KitchenAid W11179813A 18 halaman.

6. With the burner ON (the burner will have to be lit manually

with a lighter), and set to simmer LOW, adjust the simmer

flame down to the proper BTU level. Using a 1/8" x 4¼"

(3.2 mm x 10.8 cm) flat blade screwdriver, turn the simmer

low‑turndown adjustment screw clockwise until the flame

height is at, or below, the bottom of the cap. If the flame

becomes unstable and flickers or appears to race around the

burner, the adjustment is too low and the screw should be

adjusted counterclockwise until the flame is stable. Repeat

this step for all surface burners.

NOTE: Use a knob to adjust the burner valve.

NOTE: Adjust each burner individually.

7. After adjustments are completed, replace the ignition

switches onto the valves.

8. Lift up on the control console and set it back into place. For

a proper fit, the flange of the control console must hook over

the lip on the front of the cooktop.

NOTE: It may be necessary to lift valve stems to align with

console holes.

A. Control console flange

B. Front lip of cooktop

9. Check that the control console is flush with the top edge of

the cooktop.

A. Flush with cooktop

10. Replace the screws on each side of the control console.

11. Replace the bezels using the 2 screws which attach to the

valve brackets, making note that there are front and rear

bezels and will only attach properly in the correct location on

the console.

12. Push the Surface Knobs onto the valve stems.

13. Replace the burner grates.

Complete Installation

1. Refer to the "Make Gas Connection" section for properly

connecting the cooktop to the gas supply.

2. Refer to the "Electronic Ignition System" section for proper

burner ignition, operation, and burner flame adjustments.

IMPORTANT: You may have to adjust the "LO" setting for

each cooktop burner.

Checking for proper cooktop burner flame is very important.

The small inner cone should have a very distinct blue flame

1/4" (6.4 mm) to 1/2" (1.3 cm) long. The outer cone is not as

distinct as the inner cone. Propane gas flames have a slightly

yellow tip.

3. Refer to "Complete Installation" in the "Installation

Instructions" section of this manual to complete this

procedure.