KitchenAid KDC-38 Panduan Petunjuk Instalasi
Jelajahi secara online atau unduh pdf Panduan Petunjuk Instalasi untuk Mesin pencuci piring KitchenAid KDC-38. KitchenAid KDC-38 6 halaman.
Halaman CetakDISHWASHER-SINK
COMBINATION
KDC-38 & KDS-38
INSTALLATION
INSTRUCTIONS
MR. INSTALLER:
FINAL
CHECK LIST
PLACEMENT
OF DISHWASHER
- SINK COMBINATION
0
1. Remove corrugated
motor block packing from rear of unit after dishwasher
is removed from skid.
n
2. Properly
positioned-level,
aligned and square with cabinet opening.
n
3. Anchored
securely, either to cabinet or floor.
n
4. Installation
debris removed from under dishwasher.
ELECTRICAL
CONNECTION
n
1. Separate 115 volt, 60 hertz,
1 phase branch circuit
with
a 15 ampere minimum
protected
by a
maximum
of 15 ampere fuse size.
n
2. Dishwasher
properly
grounded.
n
3. All connections
in conformance
with
local electrical
code.
PLUMBING
0
1. Water supply
at dishwasher:
20 to 120 P.S.I. pressure, temperature
of 140" F.
to 160"
F. and l/2"
O.D. (min.)
copper tube.
n
2. Drain
lines at least 5/8"
O.D. copper tubing
or equivalent
without
drain
air gap
and with
no tight
bends (kinks)
or other
restrictions
to prevent
complete
draining.
0
3. Drain
lines at least g/16"
I.D. copper
tubing
or equivalent
with
drain air gap
and with
no tight
bends (kinks)
or other
restrictions
to prevent
complete
draining.
n
4. Compliance
with
all aspects of local plumbing
code.
n
5. Make sure drain
hose does not touch
any electrical
components
or terminals.
OPERATIONAL
Cl
1. All internal
packing material,
labels, and foam door pads removed.
Place detergent
in both compartments
of detergent
dispenser,
close cover(s)
and
operate dishwasher
through
complete
"Normal
Cycle,"
Note:
KDC has cover over
only one of two compartments.
Check:
Proper
Fill-Water
level approximately
l-1/2"
below
centerline
of 4 Way Hydro
Sweep hub. Complete
Drain.
Detergent
Dispenser-must
operate automatically
and completely
dispense
detergent.
Dishracks,
for freedom
of movement
and adjustment.
THANK
YOU
MR.
INSTALLER:
1. Complete
Installation
Check
List.
2. Leave all literature
(Incl.
Check List) for customer.
3. Notify
dealer that electrical
work
and plumbing
are completed.
FOR DETAILED
INffRUCTIONf, FOLLOW METHODS DESCRIBED IN THIS FOLDER